SDS

SDS Number: 00079201001 Revision Date: 2/13/2019
SAP Number:
Titanium dioxide 10 mg/m3 TWA N.E. 15 mg/m3 TWA
total dust
N.E.
Propylene carbonate N.E. N.E. N.E. N.E.
n-Butyl acetate 50 ppm TWA Butyl
acetates, all isomers
150 ppm STEL Butyl
acetates, all isomers
150 ppm TWA, 710
mg/m3 TWA
N.E.
Isopropyl alcohol 200 ppm TWA 400 ppm STEL 400 ppm TWA, 980
mg/m3 TWA
N.E.
Ethyl acetate 400 ppm TWA N.E. 400 ppm TWA,
1400 mg/m3 TWA
N.E.
Attapulgite N.E. N.E. N.E. N.E.
C.I. pigment yellow 42 N.E. N.E. N.E. N.E.
Further Advice: MEL = Maximum Exposure Limit OES = Occupational Exposure Standard SUP = Supplier's Recommendation
Sk = Skin Sensitizer N.E. = Not Established
Personal Protection
RESPIRATORY PROTECTION: When concentrations exceed the exposure limits specified, use of a NIOSH-approved
dust, mist and fume respirator is recommended. Where the protection factor of the respirator may be exceeded, use of
a full facepiece, supplied air, or Self Contained Breathing Apparatus (SCBA) may be necessary. If concentrations
exceed the exposure limits specified, use of a NIOSH-approved supplied air respirator is recommended. Where the
protection factor is exceeded, use of a Self Contained Breathing Apparatus (SCBA) may be necessary.
SKIN PROTECTION: Solvent-resistant gloves. Wear protective gloves.
EYE PROTECTION: Goggles or safety glasses with side shields.
OTHER PROTECTIVE EQUIPMENT: Provide eyewash and solvent impervious apron if body contact may occur.
Solvent-resistant apron.
HYGIENIC PRACTICES: Remove and wash contaminated clothing before re-use.
9. Physical and Chemical Properties
Appearance: Colored Physical State: Paste
Odor: Strong Solvent Odor Threshold: Not Established
Density, g/cm3: 1.08 - 1.22 pH: Not Applicable
Freeze Point, °C: Not Established Viscosity (mPa.s): Not Established
Solubility in Water: No Information Partition Coeff., n-octanol/water: Not Established
Decomposition Temperature, °C: Not Established Explosive Limits, %: N.E. - N.E.
Boiling Range, °C: N.E. - N.E. Auto-Ignition Temperature, °C Not Established
Minimum Flash Point, °C: -15 Vapor Pressure, mmHg: Not Established
Evaporation Rate: Not Established Flash Method: Pensky-Martens
Closed Cup
Vapor Density: Not Applicable
Flammability, NFPA: Flammable Liquid
Class IA
Combustibility: Does not support combustion
(See "Other information" Section for abbreviation legend)
(If product is an aerosol, the flash point stated above is that of the propellant.)
10. Stability and Reactivity
STABILITY: Stable under recommended storage conditions.
Page 4 / 7