Technical Specifications

08/2018 | www.dap.com
Preparation:
1. SAFETY FIRST! PRODUCT IS EXTREMELY FLAMMABLE WHILE DISPENSING! READ
AND UNDERSTAND ALL OF THE PRECAUTIONARY MEASURES FOR USE, HANDLING,
STORAGE AND DISPOSAL CONTAINED IN THE PRODUCT LABEL AND SAFETY DATA
SHEET (SDS).
2. Extinguish all ignition sources during use and cure.
3. Shakewell for 1-2- minutes before using.
4. Be sure surfaces to be bonded are clean, dry, and free of all foreign materials.
5. Remove red applicator lock from spray can by sliding upwards and discarding.
APPLICATION:
1. Wear safety glasses and use in well-ventilated areas.
2. Hold can 6-8 inches from the surface to be sprayed.
3. Keep can moving while spraying to get an even film of adhesive on the surface to be bonded.
4. More than one coat may be required on absorbent/porous surfaces. Test application verbiage and
cautions regarding not for use on surfaces prone to solvent degradations/soak through
5. Permanent Bonds: Be sure to spray both surfaces and allow to dry to a tack.
6. Allow 5-10 minutes prior to bonding, make bond while the adhesive is aggressively tacky.
AFTER USE:
1. Store glued assembly out of direct sunlight and in stable conditions until fully dried
(approximately 24 hours).
2. Clean spray tip by inverting can and spraying until no more adhesive is present or using a
mineral spirits or acetone.
3. Clean excess wet adhesive from surfaces and tools with mineral spirits. Dried adhesive must
cut or scraped away. Clean hands with warm water and soap. DO NOT use solvents to
remove product from skin. Store container in cool, dry place away from extreme heat or cold.
APPLICATION