SDS

SDS Number: 00030406004 Revision Date: 1/16/2019
SAP Number:
FIRST AID - INGESTION: Make sure airways are clear. Adhesive will immediately polymerize in mouth and will be impossible to
swallow. Saliva will slowly separate the adhesive from mouth.
5. Fire-fighting Measures
UNUSUAL FIRE AND EXPLOSION HAZARDS: Vapor from this material will readily ignite at temperatures above 150 degrees F if an
ignition source is present. Vapors may form an explosive mixture with air at temperatures above 150 degrees F. Eliminate sources of
ignition: heat, electrical equipment, sparks and flames.
SPECIAL FIREFIGHTING PROCEDURES: Wear self-contained breathing apparatus pressure-demand (NIOSH approved or
equivalent) and full protective gear. Use water spray to cool exposed surfaces.
EXTINGUISHING MEDIA: Alcohol Foam, Carbon Dioxide, Dry Chemical, Foam
6. Accidental Release Measures
ENVIRONMENTAL MEASURES: No Information
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: Immediately eliminate sources of ignition. Contain spilled
material and remove with inert absorbent. Dispose of contaminated absorbent, container and unused contents in accordance with
local, state and federal regulations. Dike to prevent entering any sewer or waterway. Transfer liquid to a holding container. Read all
product instructions before using. Personal protective equipment should include impervious gloves, protective eye wear, and suitable
work clothes. In case of spillage, absorb with inert material and dispose of in accordance with applicable regulations. Use absorbent
material or scrape up dried material and place in container.
7. Handling and Storage
HANDLING: KEEP OUT OF REACH OF CHILDREN!DO NOT TAKE INTERNALLY. Keep away from open flames, hot surfaces and
sources of ignition. Provide adequate ventilation. Wear appropriate personal protection. Avoid contact with eyes, skin and clothing.
STORAGE: Store away from sources of ignition and heat. Do not store at temperatures above 120 degrees F. Store containers
away from excessive heat and freezing. Store away from caustics and oxidizers. Keep containers tightly closed.
8. Exposure Controls/Personal Protection
Ingredients with Occupational Exposure Limits
Chemical Name ACGIH TLV-TWA ACGIH-TLV STEL OSHA PEL-TWA
OSHA PEL-CEILING
Ethyl cyanoacrylate 0.2 ppm TWA
Cyanoacrylates
1 ppm STEL
Cyanoacrylates
N.E. N.E.
Dimethyl sebacate N.E. N.E. N.E. N.E.
Fumed silica N.E. N.E. N.E. N.E.
Further Advice: MEL = Maximum Exposure Limit OES = Occupational Exposure Standard SUP = Supplier's Recommendation
Sk = Skin Sensitizer N.E. = Not Established
Personal Protection
RESPIRATORY PROTECTION: No personal respiratory protective equipment normally required.
SKIN PROTECTION: Chemical-resistant gloves and chemical goggles should be used to prevent skin and eye contact.
None Required.
EYE PROTECTION: Safety glasses with side-shields.
OTHER PROTECTIVE EQUIPMENT: Wear suitable gloves and eye/face protection. Not required under normal use.
Page 3 / 6