SDS

SDS Number: 00080040001 Revision Date: 11/12/2019
SAP Number:
The text for GHS Hazard Statements shown above (if any) is given in the "Other information" Section.
4. First-aid Measures
FIRST AID - INHALATION: If you experience difficulty in breathing, leave the area to obtain fresh air. If continued difficulty is
experienced, get medical attention immediately.
FIRST AID - SKIN CONTACT: Wash skin with soap and water for 15 minutes. Get medical aid if symptoms persist.
FIRST AID - EYE CONTACT: In case of contact, immediately flush eyes with large quantities of water for at least 15 minutes until
irritation subsides. Get medical attention immediately.
FIRST AID - INGESTION: If swallowed, DO NOT INDUCE VOMITING. Get medical attention immediately.
5. Fire-fighting Measures
UNUSUAL FIRE AND EXPLOSION HAZARDS: No Information
SPECIAL FIREFIGHTING PROCEDURES: Wear self-contained breathing apparatus pressure-demand (NIOSH approved or
equivalent) and full protective gear. Use water spray to cool exposed surfaces.
EXTINGUISHING MEDIA: Alcohol Foam, Carbon Dioxide, Dry Chemical, Foam, Water Spray or Fog, Water
6. Accidental Release Measures
ENVIRONMENTAL MEASURES: No Information
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: In case of spillage, absorb with inert material and dispose of in
accordance with applicable regulations.
7. Handling and Storage
HANDLING: KEEP OUT OF REACH OF CHILDREN!DO NOT TAKE INTERNALLY. Use only with adequate ventilation. Ensure fresh
air entry during application and drying. Do not breathe dust. Removal of this product after use will result in the generation of Dust. If
dry-sanded, exposure to dust may result in the build-up of material in eyes, ears, nose, and mouth which may cause irritation. While
dry sanding, use of a NIOSH-approved dust mask is recommended. Wash thoroughly after handling.
STORAGE: Avoid excessive heat and freezing. Do not store at temperatures above 120 degrees F. Store away from caustics and
oxidizers. Keep containers tightly closed.
8. Exposure Controls/Personal Protection
Ingredients with Occupational Exposure Limits
Chemical Name ACGIH TLV-TWA ACGIH-TLV STEL OSHA PEL-TWA
OSHA PEL-CEILING
Clay 2 mg/m3 TWA
particulate matter
containing no
asbestos and <1%
crystalline silica,
respirable
particulate matter
N.E. 15 mg/m3 TWA
total dust, 5 mg/m3
TWA respirable
fraction
N.E.
Further Advice: MEL = Maximum Exposure Limit OES = Occupational Exposure Standard SUP = Supplier's Recommendation
Sk = Skin Sensitizer N.E. = Not Established
Personal Protection
RESPIRATORY PROTECTION: When concentrations exceed the exposure limits specified, use of a NIOSH-approved
dust, mist and fume respirator is recommended. Where the protection factor of the respirator may be exceeded, use of
a full facepiece, supplied air, or Self Contained Breathing Apparatus (SCBA) may be necessary. If concentrations
exceed the exposure limits specified, use of a NIOSH-approved supplied air respirator is recommended. Where the
protection factor is exceeded, use of a Self Contained Breathing Apparatus (SCBA) may be necessary. Use an
approved NIOSH/OSHA respirator if dry sanded. A respiratory protection program that meets the OSHA 1910.134 and
ANSI Z88.2 requirements must be followed whenever workplace conditions warrant a respirator's use.
Page 2 / 5