Use and Care Manual
2
Excellent Adhesion to:
• Vinyl
• Aluminum
• Fiber cement
• Wood
• Glass
• Tile
• Metal
• Masonry*
• Brick*
• Concrete*
• Plastic
• Drywall/plaster
*Note: For application on masonry, brick and concrete, surface must be dry to obtain maximum adhesion. Primer is
recommended for applications exposed to water.
Performance Characteristics:
• Indoor/Outdoor Use
• Permanently Flexible
• Wet Weather Washout Resistance
• No Shrinkage
• Sub-zero Temperature Application
• Excellent Durability
• No Cracking
• No Yellowing
• Resists Dirt Pick-up
• Excellent UV Resistance
• Non-Staining
• Low Odor, Low VOC
Surface Preparation & Application:
1. Surface must be clean, dry & free of caulk. 2. Cut nozzle at 45° angle to desired bead size. 3. Puncture
inner foil seal. 4. Load into caulking gun. 5. Fill gap. If joint depth exceeds 1/2” x 1/2”, use backer rod.
6. Smooth bead. 7. Clean up excess w/ mineral spirits. Scrape away cured sealant. 8. Paintable after tack
free (less than 2 hours depending on temp./ humidity). NOTE: Paintable w/ most latex paints. For best
results, use latex primer for oil-based paints. Not for window glazing or continuous underwater use.
Store below 80°F. Apply in temps. between -35°F & 140°F. Indoor/outdoor use.
For Best Results:
• Store caulk away from extreme heat or cold
• Not recommended for use underwater or below grade, on stovepipes, or chimneys, fireplace
applications, tuck-pointing, or surface defects.
• Joint width should not exceed 1/2”. If joint depth exceeds 1/2”, use a backer rod or a polyethylene
foam as a backup filler.
• Not recommended for structural glazing.
• Do not use where abrasion and physical abuse are encountered.
• Allow 24 hours for sealant to cure. Sealant will not cure in totally confined spaces.
Physical & Chemical Characteristics:
Base: Siliconized Polyether (SiP)
Solvents: No solvents
Solids: 100% by weight
Storage Temperature: Store below 80
O
F
Temperature Service Range
(Cured Sealant): -65
O
F to 350
O
F
Temperature Application Range: -35
O
F to 140
O
F
Weight per gallon: 12.5 +/- 0.1 lbs. per gallon
Consistency: Smooth Paste
Open or Tooling Time: 30 minutes