MSDS

Extinguishing Media: Carbon Dioxide, Dry Chemical, Foam
Unusual Fire And Explosion Hazards: None known.
Special Firefighting Procedures: Cool fire-exposed containers using water spray.
Steps To Be Taken If Material Is Released Or Spilled: Wear proper protective equipment as specified in Section 8.
Scrape up dried material and place into containers.
Handling: KEEP OUT OF REACH OF CHILDREN! Do not breathe vapors. Wash thoroughly after handling. Avoid
excessive heat and handling. Do not breathe dust. While dry sanding, use of a NIOSH-approved dust mask is
recommended. Avoid contact with eyes, skin and clothing. Removal of this product after use will result in the generation of
Dust. If dry-sanded, exposure to dust may result in the build-up of material in eyes, ears, nose, and mouth which may
cause irritation.
Storage:
Store away from caustics and oxidizers. Do not store at temperatures above 120 degrees F. Keep tightly closed.
Avoid excessive heat and freezing.
Precautionary Measures: Please refer to other sections and subsections of this MSDS.
Engineering Controls: Local ventilation of emission sources may be necessary to maintain ambient concentrations
below recommended exposure limits. Wet sanding is recommended to avoid generation of dust. Prevent build-up of dust
and vapors by opening windows and doors or use other means to ensure fresh air entry during application, drying and
sanding.
Respiratory Protection: A respiratory protection program that meets the OSHA 1910.134 and ANSI Z88.2 requirements
must be followed whenever workplace conditions warrant a respirator's use. If concentrations exceed the exposure limits
specified, use of a NIOSH-
approved supplied air respirator is recommended. Where the protection factor is exceeded, use
of a Self Contained Breathing Apparatus (SCBA) may be necessary. Use an approved NIOSH/OSHA respirator if dry
sanded.
Skin Protection: Wear gloves with repeated or prolonged use.
Eye Protection: Safety glasses with side-shields.
Other protective equipment: Not required under normal use.
Hygienic Practices: Remove and wash contaminated clothing before re-use.
Flash Point, F:
Greater than 200 degrees
Lower Explosive Limit, %:
Not Established
Method: (
Seta Closed Cup)
Upper Explosive Limit, %:
Not Established
Section 6 - Accidental Release Measures
Section 7 - Handling And Storage
Section 8 - Exposure Controls / Personal Protection
Section 9 - Physical And Chemical Properties
Boiling Range:
Not Established
Vapor Density:
Not Established
Odor:
Slight Sweet
Odor Threshold:
Not Established
Appearance:
White to Off
-
White
Evaporation Rate:
Not Established
Solubility in H2O:
Not Established
Specific Gravity:
0.48
Freeze Point:
Not Established
pH:
Between 7.0 and 12.0
Page
3
of
6
00010410001 English