Use and Care Manual

Surface Preparation & Application:

 Surface must be clean, dry and free of foreign material.

 Mix gently before use.

 Using a clean putty knife, press spackling into hole or crack. Draw blade firmly across the surface to

remove excess material in one strike.

 For a smoother finish, dip putty knife into water and lightly smooth spackling.

 One coat should be sufficient for small repairs

 May be painted within minutes with a latex paint. Please follow paint manufacturer’s instructions for

application.

 If sanding is desired, or if an oil-based paint is to be used, allow to dry thoroughly (approximately 24

hours).

 Clean tools immediately with water.

For Best Results:

 Do not apply when temperatures are below 40°F.

 Do not apply outside if rain is expected within 24 hours.

 Do not use on floors or as a caulk, sealant or joint filler over cracks and joints where expansion and

contraction may occur.

 DO NOT USE AS A SKIM COAT.

 For exterior application, first apply exterior-grade primer, then apply spackling and finish with coating

of quality exterior-grade paint.

 Do not use for tuck pointing applications on brick.

Physical & Chemical Characteristics:

Consistency: Thick Paste

Vehicle: Latex Polymer

Volatile: Water

Filler: Inert Filler

Odor: Slight Acrylic

Weight/Gallon: 3.9 ± .3 pounds

Solids: 72.5 ± 1% by weight

Application Temperature: 40° F Minimum

Service Temperature: -20ºF to 150ºF

Shelf Life: 12 Months

Freezing: Freeze/Thaw Stable 5 Cycles at 0ºF

Painting: Takes either oil or latex-base paint

MSDS No.: 000 10410 001

Clean Up:

Wash tools immediately after use with water. Dried material must be cut of scraped away. Be sure

container lid is closed and tightly sealed. Store in a cool, dry place away from extreme heat or cold.

Safety:

WARNING! IRRITANT. Contains: Sodium silicate glass, calcium carbonate and sodium Borate. May be

harmful if inhaled. May cause eye, skin and respiratory irritation. Harmful if swallowed or absorbed through

the skin. Do not breathe vapors or dust. Use only with adequate ventilation. Prevent build‐up of dust and

vapor by opening windows and doors or use other means to ensure fresh air entry during application, drying

and sanding. Dry sanding of this product may generate dust. Inhalation of dust may cause lung damage or

other adverse pulmonary and respiratory effects. When sanding, wear a NIOSH‐approved dust mask. Follow

dust mask manufacturer’s directions for use. Keep exposure below OSHA permissible exposure limits.

Avoid contact with eyes, skin and clothing. Wear gloves and safety glasses. Close container after use. Wash