Use and Care Manual

TECHNICAL DATA SHEET
Surface Preparation & Application Instructions:
• Surface must be clean, dry and free of foreign material.
• If using squeeze tube, knead tube before use and cut nozzle to desired opening size.
• Apply with a clean putty knife.
• For a smoother finish, dip putty knife in water and lightly smooth.
• One application is usually sufficient for small repairs. For repairs deeper than 1/8”, apply two or more layers
allowing to dry between applications.
• May be sanded and/or painted in 2 to 4 hours depending on temperature, humidity and depth of fill.
Wet sanding is recommended to avoid generation of dust.
• Clean tools immediately with water.
For Best Results:
• Do not apply when temperatures are below 40°F.
• Allow product to fully cure before exposing to water, approximately 24 hours.
• Do not use on floors or as a caulk, sealant or joint filler over cracks and joints where expansion and
contraction may occur.
• DO NOT USE AS A SKIM COAT.
• A topcoat is not required, however, if desired, product can be painted with a high-quality latex-based paint.
• Staining is not recommended.
• Not for continuous underwater use.
Typical Physical & Chemical Characteristics:
Consistency
Paste
Vehicle
Acrylic Latex
Volatile
Water
Odor
Slight
Weight/Gallon
13 lbs./gallon
Solids
7
9%
Application Temperature
40
°F - 150°F
Service
Temperature
0
°F to 120°F
Shelf Life
12
months
Freezing
Passes
5 cycles of 16 hours at 0°F / 8 hours at 73°F
Dry
Time
2 to 4 hours depending on temperature, humidity and depth of fill
SDS Number
00010501001
DAP® Platinum Patch®
Advanced Exterior Filler
Page 2 of 3