SDS

SDS Number: 00070082001 Revision Date: 2/13/2019
SAP Number:
Clay 2 mg/m3 TWA
particulate matter
containing no
asbestos and <1%
crystalline silica,
respirable
particulate matter
N.E. 15 mg/m3 TWA
total dust, 5 mg/m3
TWA respirable
fraction
N.E.
Butadiene-styrene copolymer N.E. N.E. N.E. N.E.
Petroleum hydrocarbon resin N.E. N.E. N.E. N.E.
Toluene 20 ppm TWA N.E. 200 ppm TWA 300 ppm Ceiling
Methylcyclopentane N.E. N.E. N.E. N.E.
3-Methylpentane 500 ppm TWA
Hexane isomers
other than n-hexane
1000 ppm STEL
Hexane isomers
other than n-hexane
N.E. N.E.
Magnesite N.E. N.E. N.E. N.E.
2-Methylpentane 500 ppm TWA
Hexane isomers
other than n-hexane
1000 ppm STEL
Hexane isomers
other than n-hexane
N.E. N.E.
Titanium dioxide 10 mg/m3 TWA N.E. 15 mg/m3 TWA
total dust
N.E.
Further Advice: MEL = Maximum Exposure Limit OES = Occupational Exposure Standard SUP = Supplier's Recommendation
Sk = Skin Sensitizer N.E. = Not Established
Personal Protection
RESPIRATORY PROTECTION: If concentrations exceed the exposure limits specified, use of a NIOSH-approved
supplied air respirator is recommended. Where the protection factor is exceeded, use of a Self Contained Breathing
Apparatus (SCBA) may be necessary. In case of insufficient ventilation, wear suitable respiratory equipment. A
respiratory protection program that meets the OSHA 1910.134 and ANSI Z88.2 requirements must be followed
whenever workplace conditions warrant a respirator's use.
SKIN PROTECTION: Solvent-resistant gloves.
EYE PROTECTION: Goggles or safety glasses with side shields.
OTHER PROTECTIVE EQUIPMENT: Provide eyewash and solvent impervious apron if body contact may occur.
HYGIENIC PRACTICES: Remove and wash contaminated clothing before re-use.
Page 4 / 8