MSDS

ManualsBrandsDAP ManualsPaintBeats the Nail 10.3 oz. Subfloor and Deck Construction Adhesive (12-Pack)

SDS Number: 00010301001 Revision Date: 5/4/2015

24 Hour Emergency Phone Numbers:

Medical/Poison Control:

In U.S.: Call 1-800-222-1222

Outside U.S.: Call your local poison

control center

Transportation/National Response

Center:

1-800-535-5053

1-352-323-3500

NOTE: The National ResponseCenter

emergency numbers to be used only in the event

of chemical emergencies involving a spill, leak,

fire, exposure or accident involving chemicals.

Safety

Data

Sheet

IMPORTANT: Provide this information to employees, customers, and users of this product. Read this SDS before handling or disposing of this

product. This product is covered by the OSHA Hazard Communication Standard and this document has been prepared in accordance with

requirements of this standard. All abbreviated terms used in this MSDS are further described in Section 16.

1. Identification

This Material Safety Data Sheet is available in American Spanish upon request.

Los Datos de Serguridad del Producto pueden obtenerse en Espanol si lo riquiere.

Product Name:

Beats The Nail Subfloor & Deck Construction

Adhesive

Revision Date: 5/4/2015

Product UPC Number:

25428

Supercedes Date: 3/5/2012

Product Use/Class: Construction Adhesive SDS No: 00010301001

Manufacturer:

DAP Products Inc.

2400 Boston Street Suite 200

Baltimore, MD 21224-4723

888-327-8477 (non-emergency matters)

Preparer: Regulatory Department

2. Hazards Identification

EMERGENCY OVERVIEW: DANGER!Flammable liquid and vapor. Vapors may cause flash fire or explosion. Vapors can form an

ignitable mixture with air. Vapors can flow along surfaces to a distant ignition source and flash back. Flammable liquid and vapor.

Vapors can form an ignitable mixture with air. Vapors can flow along surfaces to a distant ignition source and flash back. Do not

smoke. Extinguish all flames and pilot lights, and turn off stoves, heaters, electric motors and other sources of ignition during use and

until all vapors are gone. Keep container closed and away from heat, sparks, and open flame. Store away from caustics and

oxidizers. Avoid breathing vapor. Use only with adequate ventilation. Prevent build-up of vapors by opening all windows and doors

to achieve cross-ventilation. Irritating to eyes, respiratory system and skin. Harmful or fatal if swallowed. Aspiration hazard if

swallowed - can enter lungs and cause damage. Aspiration may cause pulmonary edema and pneumonitis. May affect the brain or

nervous system causing dizziness, headache or nausea.

Page 1 / 8

Summary of content (8 pages)

PAGE 1
SDS Number: 00010301001 Revision Date: 5/4/2015 24 Hour Emergency Phone Numbers: Medical/Poison Control: Safety Data Sheet In U.S.: Call 1-800-222-1222 Outside U.S.: Call your local poison control center Transportation/National Response Center: 1-800-535-5053 1-352-323-3500 NOTE: The National ResponseCenter emergency numbers to be used only in the event of chemical emergencies involving a spill, leak, fire, exposure or accident involving chemicals.
PAGE 2
SDS Number: 00010301001 Revision Date: 5/4/2015 GHS Classification Flam. Liq. 3, Repr. 2, STOT RE 2, STOT SE 3 NE, Skin Irrit. 2 Symbol(s) of Product Signal Word Warning GHS HAZARD STATEMENTS Flammable Liquid, category 3 H226 Flammable liquid and vapour. Skin Irritation, category 2 STOT, single exposure, category 3, NE H315 H336 Causes skin irritation. May cause drowsiness or dizziness.
PAGE 3
SDS Number: 00010301001 Revision Date: 5/4/2015 The text for GHS Hazard Statements shown above (if any) is given in the "Other information" Section. 4. First-aid Measures FIRST AID - INHALATION: If inhaled, remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical attention immediately. NOTE: Only trained personnel should administer artificial respiration or give oxygen. FIRST AID - SKIN CONTACT: Wash skin with soap and water for 15 minutes.
PAGE 4
SDS Number: 00010301001 Clay Revision Date: 5/4/2015 N.E. 15 mg/m3 TWA N.E. total dust, 5 mg/m3 TWA respirable fraction n-Hexane 2 mg/m3 TWA particulate matter containing no asbestos and <1% crystalline silica, respirable fraction 50 ppm TWA N.E. N.E. Toluene 2-Methylpentane 3-Methylpentane Magnesite 20 ppm TWA N.E. N.E. N.E. N.E. N.E. N.E. N.E. Methylcyclopentane Isoheptane N.E. 400 ppm TWA Heptane, all isomers 10 mg/m3 TWA N.E. 500 ppm STEL Heptane, all isomers N.E.
PAGE 5
SDS Number: 00010301001 Revision Date: 5/4/2015 9. Physical and Chemical Properties Appearance: Odor: Density, g/cm3: Freeze Point, °C: Solubility in Water: Decomposition Temperature, °C: Boiling Range, °C: Minimum Flash Point, °C: Evaporation Rate: Vapor Density: Combustibility: Tan Strong Solvent 1.11 - 1.11 Not Established Not Established Not Established N.I. - N.I. 23.9 Faster Than n-Butyl Acetate Heavier Than Air Does not Support Combustion Physical State: Odor Threshold: pH: Viscosity (mPa.
PAGE 6
SDS Number: 00010301001 Revision Date: 5/4/2015 1332-58-7 Clay 5000 mg/kg Rat 5000 mg/kg Rat N.I. 110-54-3 n-Hexane 28710 mg/kg Rat 3000 mg/kg Rabbit > 31.86 mg/L Rat 108-88-3 Toluene 636 mg/kg Rat 8390 mg/kg Rabbit 12.5 mg/L Rat 107-83-5 2-Methylpentane 28710 mg/kg Rat 3000 mg/kg Rabbit > 31.86 mg/L Rat 96-14-0 3-Methylpentane 28710 mg/kg Rat 3000 mg/kg Rabbit > 31.
PAGE 7
SDS Number: 00010301001 Revision Date: 5/4/2015 Chemical Name CAS-No. n-Hexane Toluene 110-54-3 108-88-3 TOXIC SUBSTANCES CONTROL ACT: All ingredients in this product are either on TSCA inventory list, or otherwise exempt. This product contains the following chemical substances subject to the reporting requirements of TSCA 12(B) if exported from the United States: No TSCA12(b) components exist in this product in concentrations at or above their thresholds.
PAGE 8
SDS Number: 00010301001 Revision Date: 5/4/2015 GHS02 GHS07 GHS08 Legend: N.A. - Not Applicable, N.E. - Not Established, N.D. - Not Determined DAP believes the data and statements contained herein are accurate as of the date hereof. They are offered in good faith as typical values and not as a product specification.