Use and Care Manual

©2017 DAP Products, Inc. All rights reserved.
FOR BEST RESULTS: Apply in temperatures above 40°F. Keep adhesive
above 40°F for easier gunning. One surface must be porous. Store away
from extreme heat or cold.
INSTRUCTIONS: 1. Surfaces must be clean, structurally sound, and free of
debris. 2. Pre-cut and fit materials before applying adhesive. 3. Trim nozzle to
desired bead size. ¼” recommended for most applications. 4. Puncture inner
foil seal. 5. Load cartridge into applicator gun. 6. Apply a continuous bead to
furring strips, studs, or backer material, apply “S” shaped bead to panels or
other large materials, apply straight bead to smaller materials such as crown
molding or trim. 7. Within 15 minutes, position and press substrates firmly into
place. 8. Apply mechanical fasteners and brace as needed. 9. Allow to dry for
24 hours.
CLEAN UP: Uncured adhesive: wash away with warm water and soap.
Cured adhesive: must be cut or scraped away.
USAGE INFORMATION: For usage information or warranty information,
please contact DAP Technical Customer Service at 888-DAP-TIPS or visit
dap.com & click on “Ask the Expert”.
TYPICAL PHYSICAL PROPERTIES
• Type: Synthetic Latex
• Application Temperature:
40°F to 100°F
• Service Temperature:
0°F to 140°F
• Bead Color: White
• Solids: 51%
• Shelf Life: 18 months
• Skin Time: 15 minutes
• Cure Time: 7 days
• Coverage:
o 10.3oz: ¼” bead yields 32
linear ft., 3/8” bead yields 14
linear ft.
• Calif. ARB VOC <1% Wt/Wt
• VOC Content: VOC less Water,
less Exempt Solvent: <50 g/L
•Easy Water Clean Up
•Easy To Gun
•Low Odor
•VOC Compliant
DANGER: Contains: Ethylene glycol.
May be harmful if swallowed or in contact with skin. May cause eye, skin, nose,
throat and respiratory tract irritation. Avoid breathing vapors. Use only with
adequate ventilation. Ensure fresh air entry. Avoid contact with eyes, skin and
clothing. Wear rubber gloves and eye protection with side shields.
WARNING: This product contains chemicals known to the State of California to
cause cancer, birth defects or other reproductive harm.
FIRST AID: SKIN CONTACT: Wash skin thoroughly with soap and water. EYE
CONTACT: Immediately flood with large quantities of water. INHALATION:
Remove to fresh air. INGESTION: DO NOT INDUCE VOMITING. Get medical
attention immediately if complications arise from exposure. For emergencies, call
poison control center at 1-800-222-1222. See Safety Data Sheet (SDS) for
additional information. For an SDS, contact your supplier or visit dap.com.
KEEP OUT OF REACH OF CHILDREN. DO NOT TAKE INTERNALLY.
WOOD, PANEL, TRIM
Product Features
Directions