Use and Care Manual

ManualsBrandsDAP ManualsAdhesiveDYNAGRIP 10.3 oz. Tub Surround Construction Adhesive (12-Pack)

FOR BEST RESULTS: Apply in temperatures above 40°F. Keep adhesive

above 40°F for easier gunning. One surface must be porous. Store away

from extreme heat or cold.

INSTRUCTIONS: 1. Surfaces must be clean, structurally sound, and free of

debris. 2. Pre-cut and fit materials before applying adhesive. 3. Trim nozzle to

desired bead size. ¼” recommended for most applications. 4. Puncture inner

foil seal. 5. Load cartridge into applicator gun. 6. Apply a continuous bead to

studs or backer substrate, adhesive may also be applied to back of tub

surround panel according to tub surround manufacturers installation

instructions. 7. Within 10 minutes, position and press panels firmly into place.

8. Allow to dry for 24 hours before exposing to water or moisture.

CLEAN UP: Uncured adhesive: wash away with warm water and soap.

Cured adhesive: must be cut or scraped away.

USAGE INFORMATION: For usage information or warranty information,

please contact DAP Technical Customer Service at 888-DAP-TIPS or visit

dap.com & click on “Ask the Expert”.

TYPICAL PHYSICAL PROPERTIES

• Type: Synthetic Latex

• Application Temperature:

40°F to 100°F

• Service Temperature:

0°F to 140°F

• Bead Color: White

• Solids: 51%

• Shelf Life: 18 months

• Skin Time: 15 minutes

• Cure Time: 7 days

• Coverage:

o 10.3oz: ¼” bead yields 32

linear ft., 3/8” bead yields 14

linear ft.

• Calif. ARB VOC <1% Wt/Wt

• VOC Content: VOC less Water,

less Exempt Solvent: <50 g/L

•Won’t Etch Or Burn Tub Surround Material

•Instant Grab

•Easy Water Clean Up

•VOC Compliant

DANGER: Contains: Ethylene glycol.

May be harmful if swallowed or in contact with skin. May cause eye, skin, nose,

throat and respiratory tract irritation. Avoid breathing vapors. Use only with

adequate ventilation. Ensure fresh air entry. Avoid contact with eyes, skin and

clothing. Wear rubber gloves and eye protection with side shields.

WARNING: This product contains chemicals known to the State of California to

cause cancer, birth defects or other reproductive harm.

FIRST AID: SKIN CONTACT: Wash skin thoroughly with soap and water. EYE

CONTACT: Immediately flood with large quantities of water. INHALATION:

Remove to fresh air. INGESTION: DO NOT INDUCE VOMITING. Get medical

attention immediately if complications arise from exposure. For emergencies, call

poison control center at 1-800-222-1222. See Safety Data Sheet (SDS) for

additional information. For an SDS, contact your supplier or visit dap.com.

KEEP OUT OF REACH OF CHILDREN. DO NOT TAKE INTERNALLY.

TUB SURROUND

Product Features

Directions