TDS
1/13/2023
• Shake well before spraying
• Apply in temperatures above 40F
• Spray using intermittent bursts
• Dispense a quick burst on scrap material to activate pressure
• Practice applying on scrap material before use
• Store away from direct heat in temperatures ranging from 40F to 90F
Surface Preparation
Surface must be clean, dry, structurally sound and free of all foreign material.
Make any necessary repairs to surface and ensure it is smooth and dry prior to applying spray texture.
Product Application
1. UNLOCK tab by bending backwards. THIS IS A RE-LOCKING TAB AND NOT MEANT TO BE
BROKEN OFF.
2. ADJUST nozzle upward to desired spray angle, can rotate up to 60 degrees. BE SURE TO POINT
AWAY FROM FACE AND PEOPLE.
3. TWIST nozzle to desired texture size fine, medium, or heavy.
4. SHAKE can upside down vigorously for more than one minute after hearing mixing marble moving
freely in the can. IMPORTANT Dispense a quick burst of material on scrap materials to activate
before applying to surface.
5. SPRAY holding can approximately 12 to 18 inches away from surface using intermittent bursts,
sweeping across the repair in a quick, continuous motion. For superior blending, feather texture
into surrounding repair area using the can. Add coverage as needed to match texture density. If
not satisfied, scrape off and reapply. IMPORTANT be sure that the area is well ventilated and
proper safety gear is worn.
6. PAINT, allow texture to dry for 30 minutes prior to painting. Dry time may be longer in
cooler/humid conditions or with thicker applications. Follow paint manufacturer's instructions for
best results. For exterior applications, use an exterior grade paint.
7. CLEAN-UP tools and area with towel and warm water. Place nozzle in the upright position, invert
can, point the top straight down. Spray onto a disposable surface until no texture sprays outs. Be
sure to remove any texture build up from tip/nozzle to prevent material drying on tip/nozzle.
8. STORE: Adjust spray angle to starting position and re-lock using tab.
Typical Uncured Physical Properties
Appearance/Consistency
White textured material
Base Polymer
Acrylic Latex
Weight % Solids
54%
FOR BEST RESULTS
APPLICATION
TYPICAL PHYSICAL & CHEMICAL PROPERTIES