Product specifications

Compact 8.1

Ordercode: D2321

Overview

Front Panel

1. Low Cut (Channel 1-8)

Press the LOW CUT switch to activate the high-pass filter which blends out low-frequency noise (80 Hz, 18

dB/octave).

2. Mic/Line (Channel 1-8)

Select the input channel (XLR Microphone / Unbalanced stereo RCA pin jacks).

Note: When connecting signal sources, please make sure the corresponding channel volume control and

the master faders are at their minimum settings. Otherwise unpleasant plug-in noise can occur.

3. Phantom power (Channel 1-8)

Phantom power is used for operating a capacitor microphone. As a rule, dynamic microphones can still

be used with phantom power, provided they are wired in a balanced configuration.

4. Volume control (Channel 1-8)

As part of the main mix the volume control adjusts the level of the channel signal.

5. SIG/CLIP indicator (Channel 1-8)

When a signal on the input channel is detected, the LED turns green. When the LED turns orange,

decrease the input level.

6. Frequency control

By using the frequency control, the mid range frequency can be adjusted between 330Hz and 8200Hz.

7. EQ low control

Below 80 Hz the low-frequency range is processed with a shelving filter. You can boost or cut the band up

to 12 dB. When in center position (0 dB), the equalizer has a flat response.

8. EQ mid control

The HIGH MID control adjusts the mid frequency range. This is a peak filter, which boosts and cuts the

frequency selected with the Frequency control control (6). You can boost or cut the band up to 12 dB.

When in center position (0 dB), the equalizer has a flat response.