Product guide

10
39. Track/ Folder selection
Press the control and turn to select the desired folder. Release the control and turn to select the
desired track.
41. Pitch Fader:
Use this fader to adjust the pitch of the track. Turn to the right to increase the pitch, turn to the left to
decrease the pitch.
42. Pitch:
If you push this button, you can adjust the pitch with the pitch fader.
43. Repeat:
Use this button to repeat one track or all tracks of your medium.
44. Cue:
Press this button during playback to return to the position at which playback is started.
45. PLAY/PAUSE :
Use this button to start playback. Press once to start playback, twice to set the pause mode, and
again to resume playback.
46. Fast Reverse :
Press and hold this button to play the track fast reverse.
47. Fast Forward :
Press and hold this button to play the track fast forward.
48. Pitch –:
The track slows down while this button is pressed. Release the button to return to the original BPM.
49. Pitch +:
The track speeds up as long as this button is pressed. Release the button to return to the original BPM.
Fig. 8
50. GND
Use to connect the ground wire of your turntable.
51. GND
Use to connect the ground wire of your turntable.
52. AC Inlet
This connector is meant for the connection of the supplied main cord. Connect one end of the power
cord to the connector, the other end to the mains, then turn on the power switch to operate the unit.
Note: Please make sure that the supply voltage matches the operation voltage before connecting
the unit to mains.
53. Master XLR Balanced Out
Use these outputs to connect an amplifier with balanced inputs.
54. Trim Output Control
Use this control to match your master out optimally to your amplifier.
Note: If the control is turned completely to the left, there is no output signal.
55. Fader Start B
1/4” jack for remote fader start.
56. Fader Start A
1/4” jack for remote fader start.
57. Master RCA Unbalanced Out
Use these outputs to connect an amplifier with unbalanced inputs.
58. Zone RCA Unbalanced Out
Use these outputs to connect an amplifier with unbalanced inputs.