Product guide

14
50. Ctrl Room/Phones level control
This control allows you to adjust the volume of the
Control Room (82, 83) outputs and the Headphones
(70) outputs. Depending on the type of headphones
connected to the phones jack, the Powermix is
capable of producing very high output levels via the
phones output. Therefore, make sure to turn the
control all the way down (minimum setting) before
connecting the headphones.
Warning: Listening to loud sound pressure levels over
a longer period of time leads to hearing damage!
51. Phantom Power Switch
Press this button to turn the phantom power +48V on.
Do not connect any unbalanced microphones with
the phantom power switched on. The red Phantom
LED (52) will light if the phantom power is activated.
52. Phantom Power LED
This LED indicates when the phantom power is switched on for the microphone inputs. After switching on
the mixer, the red LED should not light up. So both balanced and unbalanced microphones can be
connected. Unbalanced microphones may be damaged if the Phantom power is activated however
unbalanced microphones are rarely to be found these days.
Make sure to close the fader of the corresponding input channel or at least the MASTER controls before
connecting any audio signal sources. This will save yourself, your audience, and your equipment from
unnecessary stress resulting from plug-in noise.
53, 58. Stereo Tape in inputs
Unbalanced RCA.
54, 55. Stereo Rec out outputs
Unbalanced RCA.
56. Stereo jack rec out output
Stereo 3,5mm jack.
57. Stereo jack tape in input
Stereo 3,5mm jack.
59. USB/tape to aux 1 bus level control
The stereo signal of the tape (53, 58, 57)/USB (84) input is summed to a mono aux signal and is routed to
the aux 2 bus. You can adjust the level of the tape (53, 58, 57)/ USB (84) inputs in the (mono) aux 1 mix
with this control.
60. USB/tape to aux 2 bus level control
The stereo signal of the tape (53, 58, 57)/USB (84) input is summed to a mono aux signal and is routed to
the aux 2 bus. You can adjust the level of the tape (53, 58, 57)/ USB (84) inputs in the (mono) aux 2 mix
with this control.
61. Tape in/USB control
This control allows you to control the level of the tape in (53, 54, 57) and/or USB (84) input in the main (ST)
mix.
62. Control room button
This button allows you to route the signal of the tape/USB section to the control room group.
63. Main button
This button allows you to route the signal of the tape/USB section to the main group.