Specifications

7. GROUP SELECTOR (GROUP BUS ASSIGH SWITCH)
When these switch are on , the signal of each channel will be sent to the 8 GEROUP buses. These switches is
arranged in two columns.
Odd numbered Left(Group 1, 3, 5, 7) and even numbered, Right(Group 2, 4, 6, 8) indicating which "side" of the
BALANCE control they will be assigned to.
8. CHANNEL MUTE SWITCH
When this switch is engaged, (depressed position) the signal of each stereo channel will be muted in the MAIN
MIX L/R buses, the Group1-8 buses and AUX 3-4 buses.
The channel MUTE switch does not affect the pre-position of the AUX 1 ＆ 2 signal on the STEREO PANEL,
but, it does affect the post-position of the AUX 3 ＆ 4 signal on the STEREO 2,4 PANEL.
9.CHANNEL SOLO SWITCH
The channel SOLO switch assigns the output of the channel PAN control to the stereo solo buses.
10.CHANNEL FADER
This fader controls the output level of the input channel signal, determining the volume balance between channels.
The channel fader should be lowered for unused channels.
※ PAD SWITCH(STEREO INPUT SENSITIVITY SELECT)
If you select STEREO INPUT SENSITIVITY to either-10dB or +4dB.
Look at the STEREO INPUT PC Board. The PAD SWITCH is setted 10dB position initially on STEREO INPUT PC
Board.
This switch selects the appropriate gain for the input signal level.
The sensitivity is -10dB when the switch is slided toward left hand side, and + 4dB when it is slided toward right hand
side.
C78
-10dB
R109
SW9
IC7
C79
R108
C81
C80
J129
R116
R117
C89
R119
C90
C94
R114
-10dB
+4dB
PAD
+4dB
C95
R123
R124
C97
C98
R115
J138
R122
SW10
R128
IC8
R136
C103
R139
C107
R143
R140
C105
C104
R137
C106
J145
J143
C100
J142
J140
C99
R129
C96
J139
R102
R103
8 BUS MIXING CONSOLE
10