Specifications

PHASE(Normal)

1.GND

2.(+)

3.(-)

PHASE(Reverse)

1.GND

2.(-)

3.(+)

Group Out Jack Pin

4. 8 GROUP OUTPUT JACKS

These connectors deliver the main GPOUP output signal to the power amplifiers which will drive the main house

speakers in a sound reinforcement system.

These are electronically balanced outputs with a rated level / impedance of + 4dB / 600Ω. Each group output

connector is connected another 2 jacks in parallel as follows.

(GROUP1∥GROUP9∥GROUP17, GROUP2∥GROUP10∥GROUP18,

GROUP3∥GROUP11∥GROUP19, GROUP4∥GROUP12∥GROUP20,

GROUP5∥GROUP13∥GROUP21, GROUP6∥GROUP14∥GROUP22,

GROUP7∥GROUP15∥GROUP23, GROUP8∥GROUP16∥GROUP24)

5. 8 GROUP OUTPUT＆MIX OUT,MONO OUT INSTER

These 1/4″TRS connectors provide an unbalanced insert patch point before the GROUP MASTER FADER.

The INSTER-IN line accepts a 0dB/600Ω signal and the INSTER -OUT line delivers a 0dB signal capable of

driving a 10k-ohm load impedance.

The GROUP INSTER inputs are convenient way of patching in a device such as a compressor/limiter for use on

an entire group of instruments.

6. CTRL ROOM CONNECTOR

These are unbalanced 1/4″phone jack with a nominal output and impedance of +4dB/600Ω.

This is where you connect your control room monitor amplifier inputs.

7. STUDIO OUT CONNECTOR

These unbalanced 1/4″phone jack with a nominal output and impedance of +4dB/600Ω.

This is where you connect your studio monitor amplifier inputs.

8. MIX-B OUT CONNECTOR

The MIX-B jack are 1/4″TRS unbalanced, with tip high , and ring and sleeve tied together as ground, nominal

level +4dB/600Ω.These jacks make the MIX-B signal available for external patching.

8 BUS MIXING CONSOLE