MANUAL ENGLISH DRX Active Series Productcode: Productname: D3634 DRX-8A D3635 DRX-10A D3636 DRX-12A D3637 DRX-15A D3640 DRX-10BA Highlite International B.V.
DRX Active Series Table of contents Warning ...............................................................................................................................................................................2 Unpacking Instructions .....................................................................................................................................................2 Safety Instructions ................................................................................................
DRX Active Series Warning FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY BEFORE YOUR INITIAL START-UP! Unpacking Instructions Immediately upon receiving this product, carefully unpack the carton and check the contents to ensure that all parts are present, and have been received in good condition. Notify the dealer immediately and retain packing material for inspection if any parts appear damaged from shipping or the carton itself shows signs of mishandling.
DRX Active Series Do not connect this device to a dimmer pack. Do not drive the inputs with a signal level bigger, than required to drive the equipment to full output. Do not insert objects into air vents. Do not open this device. Risk: hazardous radiation exposure. Do not run the output of any amplifier channel, back into another channel’s input. Do not switch the system on and off in short intervals, as this would reduce the system’s life.
DRX Active Series Connection with the mains Connect the device to the mains with the power-plug. Always pay attention, that the right color cable is connected to the right place.
DRX Active Series Features These series products include active speaker cabinets and subwoofer. ACTIVE SPEAKERS: 1. DRX-8A 2. DRX-10A 3. DRX-12A 4. DRX-15A SUBWOOFER: 1. DRX-10BA 2. DRX-12BA 3. DRX-15BA These products are design to provide a cost effective high grade solution, and they can be used for all kinds of applications, such as churches, conference center, disco, etc. You can select right model according to your request.
DRX Active Series Rear Panel Description DRX-1OBA/12BA/15BA SUB ON-OFF main power switch LINK LEFT/RIGHT ON XLR CONNECTOR Input AC power socket with main fuse SIGNAL/LIMIT, Red LED, indicate ON status POWER, Green LED, indicate ON status VOLUME main power amplifier control BYPASS Switch Select High pass filter or bypass PHASE Switch Reverse the Polarity of SUB OUT Ground Lift Switch OUT LEFT/RIGHT ON 2x XLR CONNECTOR LINE IN RIGHT ON XLR CONNECTOR POWER SWITCH SELECTOR LINE IN LEFT/MONO ON COM
DRX Active Series DRX-8A DRX-10A/12A/15A POWER LED INDICATOR GND Switch MIC IN with balanced XLR & TRS for Microphone AC Input Voltage Selector LINE OUT at 0dB on XLR & TRS connector Main Power Switch Signal Limit LED AC Power Inlet with AC Fuse Volume Control 7
DRX Active Series Connection Examples Two Active Subwoofers & Two Active Satellite Speakers 1) 2) 3) 4) 5) 6) 7) 8) Make your initial connections with all the equipment powered off and ensure that all the main volume controls are turned completely. Connect one side of the signal cable at your audio mixer into OUTPUT LEFT/RIGHT and the other side of the cable into the LINE INPUT of your active subwoofers.
DRX Active Series One Active Subwoofer & Two Active Satellite Speakers 1) Make your initial connections with all the equipment powered off and ensure that all the main volume controls are turned completely. 2) Connect one side of the signal cable at your audio mixer into OUTPUT LEFT/RIGHT and the other side of the cable into the LINE INPUT LEFT/RIGHT of your active subwoofer.
DRX Active Series Two Active Satellite Speakers 1) Make your initial connections with all the equipment powered off and ensure that all the main volume controls are turned completely. 2) Connect one side of the signal cable at your audio mixer into OUTPUT LEFT/RIGHT and the other side of the cable into the LINE INPUT LEFT/RIGHT of your active satellite speakers. 3) Connect the power cords to main. 4) Turn on your mixer first, then the active speaker cabinets.
DRX Active Series Frequency Response Diagram DRX-10BA/12BA/15BA 11
DRX Active Series DRX-8A/10A/12A/15A 12
DRX Active Series Connection Cables Take care of your cables, always holding them by the connectors and avoiding knots and twists when coiling them: This gives the advantage of increasing their life and reliability. Periodically check your cables. A great number of problems (faulty contacts, ground hum, discharges, etc.) are caused entirely by using unsuitable or faulty cables.
DRX Active Series Technical Specifications Model Active System Type Continuous Power Frequency Response SPL (1W1M) Transducer Low Active Crossover Input Connectors Input Level External Connectors Power Supply Enclosure Enclosure Construction Mounting Dimension (H x W x D) Net weight Model Active System Type Continuous Power Frequency Response SPL (1W1M) Transducer Low Active Crossover Input Connectors Input Level External Connectors Power Supply Enclosure Enclosure Construction Mounting Dimension (H x W
DRX Active Series Model Active System Type Continuous Power Frequency Response SPL (1W1M) Transducer Low Active Crossover Input Connectors Input Level External Connectors Power Supply Enclosure Enclosure Construction Mounting Dimension (H x W x D) Net weight Model System Continuous power Total harmonic distortion S/N Ratio Line input Level Input Impedance Indicator Power supply External controls SPL@1m Frequency Response Woofer Driver Horn Coverage (H*V) Enclosure Construction Mounting Dimensions (H x W x
DRX Active Series Model System Continuous power Total harmonic distortion S/N Ratio Line input Level Input Impedance Indicator Power supply External controls SPL@1m Frequency Response Woofer Driver Horn Coverage (H*V) Enclosure Construction Mounting Dimensions (H x W x D) Model System Continuous power Total harmonic distortion S/N Ratio Line input Level Input Impedance Indicator Power supply External controls SPL@1m Frequency Response Woofer Driver Horn Coverage (H*V) Enclosure Construction Mounting Dimen
DRX Active Series Model System Continuous power Total harmonic distortion S/N Ratio Line input Level Input Impedance Indicator Power supply External controls SPL@1m Frequency Response Woofer Driver Horn Coverage (H*V) Enclosure Construction Mounting Dimensions (H x W x D) DRX-15A 2-Way Active Vented Speaker Cabinet LOW: 220W / HIGH:30 W LOW-input/-3dBu 100Hz, out load 4 Ohms , THD＜0.5% HI-input/-3dBu 15KHz, out load 8Ohms, THD＜0.
DRX Active Series Notes 18
©2013 DAP Audio
