MANUAL ENGLISH Clubmate III™ Ordercode: D3265 Highlite International B.V.
Clubmate III™ Table of contents Warning ...............................................................................................................................................................................2 Unpacking Instructions .................................................................................................................................................2 Safety Instructions ........................................................................................................
Clubmate III™ Warning FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY BEFORE YOUR INITIAL START-UP! Unpacking Instructions Immediately upon receiving this product, carefully unpack the carton and check the contents to ensure that all parts are present and have been received in good condition. Notify the dealer immediately and retain packing material for inspection if any parts appear damaged from shipping or the carton itself shows signs of mishandling.
Clubmate III™ Do not connect this system to a dimmerpack. Do not switch the system on and off in short intervals, as this would reduce the system’s life. Do not open the device and do not modify the device. Do not drive the inputs with a signal level bigger, than required to drive the equipment to full output. Do not plug Mics into the console (or stagebox) while Phantom Power is on. Also mute the monitor / Pa system when turning Phantom Power on or off.
Clubmate III™ Connection with the mains Connect the device to the mains with the power-plug. Always pay attention, that the right color cable is connected to the right place.
Clubmate III™ Description of the device Features The Club mate III has 4 subs and 2 tops. It is an easy transportable, high power and high quality sound system for DJ's and bands. Easy stackable with maximum stability. Each cabinet has its own built-in amplifier, processor, limiter and crossover section. Specially designed subwoofer system with 15" high power subwoofer with 3" voice coil for handling frequencies down to 38 Hz.
Clubmate III™ Overview Subwoofer GND button When this button is pressed, it separates the signal ground from the chassis ground, enabling you to eliminate potential ground loops or low-frequency hum. Loudness button Push this button to get a fuller sound at low volume levels. Air cooling window Fullrange out XLR output This parallel output allows you to connect a satellite and/or to link more bass-cabinets in parallel.
Clubmate III™ Overview Satellite GND button When this button is pressed, it separates the signal ground from the chassis ground, enabling you to eliminate potential ground loops or low-frequency hum. Loudness button Push this button to get a fuller sound at low volume levels. Air cooling window Fullrange out XLR output This parallel output allows you to connect the subwoofer and/or link more satellites in parallel.
Clubmate III™ Ordercode: D3265 8
Clubmate III™ Set Up and Operation The satellite The Clubmate III satellite is designed to produce a mid/high spectrum of sound. The satellite is equipped with a 12” LF loudspeaker and 1,75” HF driver with a horn with a dispersion of 60˚x40˚. The built-in amplifier delivers 600W pure sound. The subwoofer Feel the bass with this 15” basscabinet. The cabinet is powered through a powerful 600W amplifier.
Clubmate III™ Connection Cables Take care of your cables, always holding them by the connectors and avoiding knots and twists when coiling them: This gives the advantage of increasing their life and reliability. Periodically check your cables. A great number of problems (faulty contacts, ground hum, discharges, etc.) are caused entirely by using unsuitable or faulty cables.
Clubmate III™ Troubleshooting This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit operates properly, do not carry out following steps. 1. If the device does not operate properly, unplug the device. 2. Check the fuse, power from the wall, all cables, etc. 3. If all of the above appears to be O.K., plug the unit in again. 4.
©2013 DAP Audio