Product guide

9
Frontside
Fig. 4
53) Mic input jack 55) Headphone volume control
54) Mic volume control 56) Headphone output jack
Backside
Fig. 5
57) DC In 5V 1000mA 60) RCA/XLR select switch
58) USB connector 61) Master output balanced XLR
59) Master output unbalanced RCA
Installation
Remove all packing materials from the Kontrol D2. Check that all foam and plastic padding is removed.
Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. The power supply is printed on the back of the device.
You can power the Kontrol D2 either by the USB connector or by an optional DC5V/1A adaptor in case
your computer’s USB interface is not able to provide sufficient power.
Connections
1 Make sure your computer’s USB interface can provide 500mA, else use the optional D1262 power
adaptor.
2. Connect the Kontrol D2 to your mixer/amplifier using the proper cables.
CAUTION: Be sure that the mixer/amplifier’s power is off, when connecting the cables.