Product guide

11
17. Needle drop sensor
The needle sensor gives you a graphic visualization of the playing time of the current song. Touching
the sensor has the same effect as if you were lifting up the pickup arm of a conventional turntable
and lower it somewhere else on the record. E.g. touching the needle drop sensor in the middle will
continue playback in the mid of the song.
18. Pitch button
This button allows you to select the maximum range for the pitch control fader.
Fig. 7
19. Pitch range indicator
Indicates the selected pitch range setup with the pitch (18) button.
20. Keylock button
Allows you to toggle the Keylock mode on or off. In Keylock mode, the pitch fader allows you to
Change the tempo of the song played back while the key of the song stays unchanged.
21. Pitch control fader
Use this fader to adjust the pitch. Slide up to decrease the pitch, slide down to increase the pitch.
22. Sample /rec Button
This button allows you to play/pause playback of the recorded sample.
While pushing and holding the shift (4) button this button allows you to start/stop recording a sample.
23. Loop length indicator
Indicates the length of the smartloop set up with the smartloop 2 (5), smartloop 4 (28), smartloop 8
(30) buttons and x½/x2 (26) switch.
24. Pitch bend + button
The track speeds up while this button is pushed in. Release the button to return to the original BPM.
25. Pitch bend – button
The track slows down while this button is pushed in. Release the button to return to the original BPM.
26. x½/x2 switch
Allows you to divide or multiply the smartloop length by 2.
27. Scratch
This button allows you to select or deselect scratch mode for the jogwheel. If the scratch mode is not
selected, the jogwheel is in jog mode.
28. Smartloop 4 button
Tapping this button starts a 4 beat loop.
29. Loop out
This button allows you to set the endpoint of the loop.
30. Smartloop 8 button
Tapping this button starts an 8 beat loop.
31. Reloop button
This button allows you to either exit or call the Loop playback.
32. Jogwheel
While not in scratch mode, the jogwheel allows you to speed up or slow down.
In scratch mode the jog wheel can be used for scratch effects.
Mixer Functions
33. Track select encoder
Depending on the browser panel (see page 23) you’re in, you can use the encoder to select a
certain track or folder. Confirm by pressing the encoder.
34. Load A button
Pushing this button loads the selected track in deck A and activates the cue function for channel 1.
The cue 1 (39) button will light up.
35. Channel 1 gain
The gain control allows you to adjust the input-sensitivity for a channel. En thus optimally matching
the incoming signals to the mixer’s internal operation level.
36/ 37/ 38. Channel 1 equalizer section (HI / MID / LOW)
Use the 3 band equalizer to adjust the tone for each channel by using the Hi, Mid and Low controls.
Push a control to kill (mute) the corresponding band.