Product guide

Setting a hot cue point in play mode

• During play mode, push the desired hot cue (cue 1 (1)/ cue 2 (2)/ cue 3 (3)) button.

• The hot cue point is stored while playback resumes.

• The hot cue point will be indicated in the waveform display as shown in figure 8.

(Hot) Cue Points Fig. 8

Deleting a hot cue point

• Push and hold the shift (4) button while tapping the corresponding hot cue button (cue 1 (1), cue 2 (2)

or cue 3 (3)) to delete a hotcue point.

Cueing

• "Cueing" is the action of preparing for playback.

• Push the cue (9) button, the player will enter cue mode, the playback returns to the cue point and

enter the deck will enter pause mode, the Cue (9) button lights up and the play/pause (11) button

flashes. When the play/ pause (11) button is pushed, playback will start from the cue point.

• If the cue (9) button is pushed after the search operation or the scanning operation, the playback

returns to the cue point and the deck will enter pause mode.

NOTE: While in cue mode, if the cue (9) button is pushed and hold, playback will start from the cue

point, when the button is released, the player will return to the cue mode automatically, it allows you to

check the cue point.

Frame search

• Frame search is a function for monitoring the sound at a certain section of the song and manually

changing the position. Searching is used to set a start point with precision.

• Dial the jogwheel (32) while in pause or cue mode to start searching.

• While dialing the jogwheel (32), the point from which the sound output moves is a number of frames

corresponding to the number of the milliseconds, and the time display in the waveform display also

changes.

• The search point moves in the forward direction when the jogwheel (32) is dialed clockwise. When the

jogwheel (32) is dialed counterclockwise, the search point will move backward.

Scanning (fast forward/fast backward)

• The needle sensor (17) gives you a graphic visualization of the playing time of the current song.

Touching the sensor has the same effect as if you were lifting up the pickup arm of a conventional

turntable and lower it somewhere else on the record. E.g. touching the needle drop sensor in the

middle will continue playback in the mid of the song.

Changing pitch of the song

There are three tools available for changing the BPM of the song:

I. Use the pitch control fader to adjust the BPM.

• Set the desired pitch bend range for the pitch control fader (21) by pushing the pitch (18) button.

Make sure that the pitch control fader (21) is not deactivated (off LED lit).

• Adjust the BPM by sliding the pitch control fader (21) up or down.