User manual

Index
© National Instruments Corporation I-3 NI-DAQ User Manual for PC Compatibles
Config_DAQ_Event_Message, 3-5
Configure_HW_Analog_Trigger, 3-4
CTR_Config, 3-77
CTR_FOUT_Config, 3-77
DAQ_Config, 3-21
DAQ_DB_Config, 3-23, 4-10
DAQ_StopTrigger_Config, 3-22
DIG_Block_PG_Config, 3-58
DIG_Change_Message_Config, 3-60
DIG_DB_Config, 3-59, 4-10
DIG_Filter_Config, 3-60
DIG_Grp_Config, 3-58
DIG_Line_Config, 3-57
DIG_Prt_Config, 3-58
DIG_SCAN_Setup, 3-59
DIG_Trigger_Config, 3-59
GPCTR_Change_Parameter, 3-93, 4-10
MIO_Config, 3-4
SCXI_Configure_Connection, 3-108
SCXI_Configure_Filter, 3-108
SCXI_Load_Config, 3-109
SCXI_MuxCtr_Setup, 3-110
SCXI_SCAN_Setup, 3-110
SCXI_Set_Config, 3-110
SCXI_Set_Excitation, 3-110
SCXI_Set_Gain, 3-111
SCXI_Set_Input_Mode, 3-111
SCXI_Set_State, 3-111
SCXI_Set_Threshold, 3-111
SCXI_Single_Chan_Setup, 3-111
SCXI_Track_Hold_Setup, 3-111
Timeout_Config, 3-3
WFM_DB_Config, 3-40, 4-10
WFM_Group_Setup, 3-40
Configure_HW_Analog_Trigger function, 3-4
conventions used in manual, xi-xvii
counter/timer application tips, 3-82 to 3-91.
See also counter/timer functions;
counter/timer operation.
concatenated event counting, 3-88 to 3-89
event counting, 3-86 to 3-89
event counting flow chart (figure), 3-82
event-counting functions, 3-82
frequency measurement, 3-87 to 3-88
general-purpose counter/timer
functions, 3-94 to 3-95
interval counter/timer functions, 3-92
period and continuous pulse-width
measurement, 3-89 to 3-91
pulse generation flow chart (figure), 3-83
pulse width measurement, 3-86 to 3-87
pulse-generation functions, 3-83 to 3-84
simultaneous counter operations
(figure), 3-85
time-lapse measurement, 3-87
timer event counting (figure), 3-86
utility functions, 3-84
counter/timer functions, 3-76 to 3-78. See also
counter/timer application tips; counter/timer
operation.
CTR_Config, 3-77
CTR_EvCount, 3-77
CTR_EvRead, 3-77
CTR_FOUT_Config, 3-77
CTR_Period, 3-77
CTR_Pulse, 3-77
CTR_Rate, 3-77
CTR_Reset, 3-77
CTR_Restart, 3-77
CTR_Simul_Op, 3-77
CTR_Square, 3-77
CTR_State, 3-78
CTR_Stop, 3-78
device support (table), 3-76
general-purpose counter/timer functions
application tips, 3-94 to 3-95
GPCTR_Change_Parameter,
3-93, 4-10
GPCTR_Config_Buffer, 3-93
GPCTR_Control, 3-93
GPCTR_Read_Buffer,
3-93, 4-11, 4-12