User manual

Index
NI-DAQ User Manual for PC Compatibles I-4 ni.com
GPCTR_Set_Application, 3-93
GPCTR_Watch, 3-93
interval counter/timer functions
application tips, 3-92
ICTR_Read, 3-91
ICTR_Reset, 3-91
ICTR_Setup, 3-91
interval counter/timer block
diagram, 3-92
counter/timer operation. See also interval
counter/timer functions; interval
counter/timer operation.
Am9513-based devices
gating modes, 3-79
timebases, 3-78
clocks or time counters, 3-95 to 3-102
clock accuracy, 3-98
clock resolution, 3-95
clock synchronization, 3-96 to 3-97
example clock in measurement
system, 3-98 to 3-99
IRIG (Inter Range Instrumentation
Group) protocols, 3-97 to 3-98
pulse per second, 3-96 to 3-97
sample code for setting up clock
usingPPS,3-96to3-97
sample use cases, 3-99 to 3-102
CTR function operation, 3-78 to 3-81
counter block diagram, 3-78
counter timing and output types
(figure), 3-81
programmable frequency output
operation, 3-81
data acquisition function application
tips, 3-24 to 3-25
interval counter/timer operation, 3-92
counter usage, in waveform
generation, 3-50 to 3-51
CTR_Config function, 3-77
CTR_EvCount function, 3-77
CTR_EvRead function, 3-77
CTR_FOUT_Config function, 3-77
CTR_Period function, 3-77
CTR_Pulse function, 3-77
CTR_Rate function, 3-77
CTR_Reset function, 3-77
CTR_Restart function, 3-77
CTR_Simul_Op function, 3-77
CTR_Square function, 3-77
CTR_State function, 3-78
CTR_Stop function, 3-78
customer education, A-1
D
DAQsystem,settingup,1-2to1-3
DAQCard-500/700 devices
data acquisition application tips, 3-25
interval counter/timer
operation, 3-91 to 3-92
DAQ_Check function, 3-21
DAQ_Clear function, 3-21
DAQ_Config function, 3-21
DAQ_DB_Config function, 3-23, 4-10
DAQ_DB_HalfReady function, 3-24, 4-12
DAQ_DB_Transfer function, 3-24, 4-11
DAQ_Monitor function, 3-21
DAQ_Op function, 3-20
DAQ_Rate function, 3-22
DAQ_Set_clock function, 3-22
DAQ_Start function, 3-22
DAQ_StopTrigger_Config function, 3-22
DAQ_to_Disk function, 3-20
DAQ_VScale function, 3-22
data acquisition application tips, 3-24 to 3-32
basic building blocks, 3-25 to 3-26
building block 1: configuration
functions, 3-26
building block 2: start
functions, 3-27 to 3-29
building block 3: check
functions, 3-30 to 3-31