Programming instructions

Chapter 12 Buffering Your Way through Waveform Generation
© National Instruments Corporation 12-7 LabVIEW Data Acquisition Basics Manual
You can use this VI in conjunction with the Cont Acq to File (scaled) VI,
located in
labview\examples\daq\anlogin\anolgin.llb
. The
Display and Output Acq’d File (scaled) VI also is described in Chapter 7,
Buffering Your Way through Waveform Generation
. After running the
Cont Acq to File (scaled) VI and saving your acquired data to disk, you can
run the Display and Output Acq’d File (scaled) VI to generate your data
from the file you created. This example uses circular buffered output. If you
want to generate the data at the same rate at which it was acquired, you
must know the rate at which your data was acquired, and use that as the
update rate
.