Programming instructions

Index
© National Instruments Corporation I-3 LabVIEW Data Acquisition Basics Manual
dividing frequencies, 28-2 to 28-3
events or elapsed time counting
connecting counters, 27-2 to 27-3
elapsed time, 27-9 to 27-10
events, 27-4 to 27-6
finite pulse train generation,
24-14 to 24-15
frequency and period measurement
connecting counters, 26-3
high frequency signals, 26-5 to 26-26
how and when to measure, 26-2
low frequency signals, 26-9 to 26-10
internal timebases with corresponding
maximum pulse width measurements
(table), 25-9
single square pulse generation,
24-4 to 24-6
square pulse generation, 24-2 to 24-3
stopping counter generations, 24-23
amplification
increasing signal-to-noise ratio
(figure), 18-4
methods for minimizing noise
(note), 18-4
amplifier offset, reading, 21-5
AMUX-64T devices
addressing with MIO boards, A-1
analog input channel range (table), 5-13
channel addressing, 5-13 to 5-17
scanning order for DAQ devices,
5-14 to 5-17
four AMUX-64Ts (table), 5-16
one or two AMUX-64Ts (table), 5-15
specifying number for AMUX-64T
device (table), 5-17
analog input.
See also
buffered waveform
acquisition.
AMUX-64T external multiplexer device,
5-12 to 5-17
analog input/output control loops,
6-6 to 6-10
channel clock control, 9-3 to 9-5, 9-8
circular-buffered analog input examples,
7-12 to 7-14
continuous acquisition from multiple
channels, 7-10 to 7-11
defining signals, 5-1 to 5-2
digital triggering, 8-2 to 8-5
external control of acquisition rate,
9-1 to 9-3
hardware triggering, 8-1 to 8-8
measurement systems, 5-4 to 5-6
multiple-channel single point analog
input, 6-3 to 6-5
multiple waveform acquisition, 7-3 to 7-5
scan clock control, 9-6 to 9-7, 9-8
SCXI applications for measuring
temperature (example), 21-2 to 21-13
selecting input settings, 5-7 to 5-12
calculating code width, 5-7
considerations for selecting,
5-7 to 5-8
differential measurement system,
5-9 to 5-10
measurement precision for various
device ranges and limit settings
(table), 5-8
nonreferenced single-ended
measurement system, 5-11 to 5-12
referenced single-ended
measurement system, 5-11
signals, 4-3, 5-1 to 5-6
single-buffered analog input examples,
7-5 to 7-8
single-channel single point analog input,
6-1 to 6-2
single waveform acquisition, 7-2 to 7-3
software triggering, 8-8 to 8-11
terminology, 5-17
triggering, 8-5 to 8-8