Programming instructions

Index
LabVIEW Data Acquisition Basics Manual I-18
© National Instruments Corporation
RSE (referenced single-ended) measurement
system, 5-11
RTD Conversion VI, 21-12
RTDs for measuring temperature,
21-10 to 21-13
run_me.llb DAQ example file, 3-2
S
SC-2042 RTD device, 21-11
Scale Constant Tuner VIs, 22-7
Scaling Constant Tuner VI, 21-5, 21-8
scan clock, 9-6 to 9-7
channel and scan intervals using channel
clock (figure), 9-1
devices without scan clocks (note), 9-6
input pins (table), 9-6
MIO device ScanClock output (note), 9-6
scan-clock orientation of LabVIEW, 9-2
simultaneous control of scan and channel
clocks, 9-8
scans
channel clock rate parameter, 5-17
defined, 5-17
interval scanning, 5-17
maximum scan rate, calculating, 7-5
number of samples parameter, 5-17
number of scans to acquire
parameter, 5-17
round-robin scanning (figure), 9-2
scan rate parameter, 5-17
SCXI-116x Digital Output VI, 21-20
SCXI-1100 One-Point Calibration example,
22-5 to 22-6
SCXI-1100 Thermocouple VI, 21-6
SCXI-1100 Two-Point calibration example,
22-6 to 22-7
SCXI-1100 Voltage example, 21-5
SCXI-1120/1121 Thermocouple example
VI, 21-10
SCXI-1122 Voltage example, 21-9
SCXI 1124 Update Channels VI,
21-16 to 21-17
SCXI-1162/1162HV Digital Input VI, 21-18
SCXI-1200 module
multiplexed mode (Windows),
19-4 to 19-5
parallel mode (Windows), 19-6
SCXI application examples, 21-1 to 21-21
analog input application for measuring
temperature, 21-2 to 21-13
analog output application, 21-16 to 21-17
DAQ example files, 3-2
digital input application, 21-17 to 21-18
digital output application, 21-19 to 21-20
multi-chassis applications,
21-20 to 21-21
overview, 21-1 to 21-2
pressure measurement with strain gauges,
21-13 to 21-16
temperature measurement applications
amplifier offset, 21-5
sensors for cold-junction
compensation, 21-3 to 21-4
using RTDs, 21-10 to 21-13
using thermocouples, 21-2 to 21-3
VI examples, 21-6 to 21-10
SCXI Cal Constants VI
automatic calculation of calibration
constants, 22-3
calibrating SCXI modules for signal
generation, 22-8
loading saved calibration constants,
22-7, 22-8
one-point calibration, 22-5
overwriting default constants in
EEPROM, 22-2
two-point calibration, 22-7