Installation & Assembly

ManualsBrandsDarby Home Co ManualsLantern Outdoor Wall LightingKelly 20'' H Beveled Glass Outdoor Wall Lantern

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .

MOUNTING THE FIXTURE

Installation (see fig.1)

1. Shut off the power at the circuit breaker and remove old fixture,

including the cross bar.

2. Carefully unpack new fixture and lay all the parts on a clear

surface. Take care not to lose any small parts necessary for

installation.

3. Thread the two mounting screws about 1/4” into the pre-drilled

holes in the mounting plate, spaced about the same distance apart

as the holes in the fixture back plate. Attach the mounting plate to

the junction box using two junction box screws. The side of the

mounting plate marked “GND” must face out.

4. Follow wiring instructions carefully (see fig.2)

5. Attach the back plate of the lamp body(C) onto the junction box,

aligning the back plate’s hole with mounting screw and lock it

securely with the hex nuts(D).

6. Install the light bulbs in accordance with the fixture’s

specifications. DO NOT EXCEED THE MAXIMUM

WATTAGE RATING!

7. Raise the cover(A) to top of lamp body(C), lock it securely with the

hex nut(B).

8. With silicone caulking compound, caulk completely around

where back of cover meets with the wall surface to prevent

water from seeping into outlet box.

Wiring (see fig.2)

1. Connect the electrical wires as follows. Connect the

black wire from the fixture to the black house (hot)

Wire. Connect the white wire from the fixture to the

white (neutral) house wire. Make sure all wire nuts are

secured. You may wrap the connections with electrical

tape.If your outlet box has a ground wire (green or bare

copper) connect fixture’s ground wire to it. Otherwise

attach the bare copper fixture wire to the green ground

screw on the cross bar.

2.Tuck the wire connections neatly into the wall junction

box.

Fig.1

UP LIGHT

Fig.2

White or

HOUSE

Black

WIRES

(Hot)

Smooth

FIXTURE

WIRES

Black or

Ribbed

WIRES

FIXTURE

Bare Copper(Ground)

FIXTURE

WIRES

Copper

(Ground)

HOUSE

(Neutral)

WIRES

White

Bare

Green or

WIRES

HOUSE

ASSEMBLING & INSTALLATION INSTRUCTIONS

OUTDOOR WALL MOUNT LIGHT FIXTURE