Installation & Assembly

ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed. However, the
installation instructions do apply to this product.
 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
 A
TTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.2, See the Page 2)
1.
Shut off the power at the circuit breaker box. Remove old fixture and all
hardware from Junction Box.
2.
Carefully unpack your new fixture and lay out all the parts on a clear area.
Take care not to lose any small parts necessary for installatio
n.
3.
Thread the two mounting screws into the pre-drilled holes in the Mounting
plate spaced the same distance apart as the holes in the canopy(A). Attach
the Mounting plate to the Junction Box with the two Junction Box screws as
shown. The side of the Mounting plate marked "GND" must face to out. The
junction box is not included.
4.
Attach the pipe thread(C) to top coupling of the lamp holder(F) and lock
it
until
tight. Attach the canopy(A) onto the pipe thread(C) and lock it until
tight.
5.
Place the candle sleeve
(E) onto the lamp holder(F).
6.
Install the light bulbs（Not included）in accordance with the fixture
specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!
7. Note:
attach the small arm to the side hole of the big ring, aligning the
arm’s screw hole with the ring’s hole, lock it securely with the screws.
The assembled is ring “G”. Attach the bell glass(H) insert to the big
ring(G). While holding the big ring(G) and canopy(A), hanging at both
hooks of the
pipe(D).
8.
While holding the fixture body assembly towards the ceiling, connect
the
electrica
l wires as Shown in Fig.2, making sure that all wire nuts are
secured. You may have to wrap the connections with electrical tape. I
f
your
outlet has a ground wire (green or bare copper), connect the fixture
ground wire to it. Otherwise connect fixture’s ground wire directly to
the
Mounting
strap with the green screw provided. After wires are c
onnected,
tuck them carefully insid
e the Junction Box.
9.
Attach the canopy(A) to the Junction box, aligning screws on single bar
with mounting holes in canopy and lock it securely with ball nu
t (B).
Y
our installation is now complete. Return power to the junction box and
test the fixture.
G
(Screwdriver )
(Not included)
The figure is
only for
reference.
A
D
B
C
E
F
H
G
Screw
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or Bare
Copper(Ground)
FIG.3
FIG.2