Caution : You must read this before you proceed Bar Stool Page 1 OF 9
Label Description QTY A Chair Back and seat 1 B Front Leg Frame (Label B) 1 C Hind Leg Frame (Label C) 1 D Left Side Rail (Label D) 1 E Right Side Rail (Label E) 1 Description QTY ① Long Bolt (M8*60MM) 9 ② Spring Washer 9 Label Picture Picture Page 2 OF 9
③ Washer 9 ④ Screw (M4*50mm) 5 ⑤ Allen Key 1 ⑥ Screwdriver 1 Pack A - for assembling the Front Leg Frame(B) &Hind Leg Frame(C)to the Chair Back and seat(A) Long Bolt Spring Washer Washer Allen Key Pack B for assembling the Left Side Rail (D)&Right Side Rails (E) to the Front Leg Frame (B ) and Hind Leg Frame(C) Screw Screwdriver Page 3 OF 9
Parts Introduction Chair Back and Seat(A) Left Side Rail(D) Hind Leg Frame(C) Front Leg Frame(B) Right Side Rail(E) This Bar Stool has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Bar Stool parts, the above picture is to help you put the various Bar Stool parts into perspective. Please read through the instructions to familiarise yourself with the parts and steps before assembly.
Step 1 A. Chair Back and seat B. Front Leg Frame D.Left Side Rail C.Hind Leg Frame E.Right Side Rail Place the Chair Back and seat(A) and Front Leg Frame (B),Hind Leg Frame(C), Left Side Rail (D)&Right Side Rail (E)on a soft surface to avoid any scratches or damages to the product and then take out the hardware. Step 2 Step:2.1 C A Table Step:2..2 C Pack A Table A 2.1 Place the chair onto the side of a table as seen in picture show.
Step 3 B B C C A A Table Table Then hold the Front Leg frame(B) insert to the Chair Back and Seat (A). Step 4 Step:4.1 Table Step:4.2 E D D A Table 4.1 Place Right Side Rail(E) into the housing of the Front Leg Frame(B) and Hind Leg Frame(C). You may need to apply a little pressure to the leg frames - pushing outwards, so as to enable the Side Rail(E) to be slotted into position. 4.2 Repeat the same process to install the Left Side Rail(D).
Step 5 Pack A B C A Table Attach the Front Leg Frame(B) to the Chair Back and Seat(A) using Pack A . At this stage, only LOOSELY FASTEN the Bolts. Step 6 B C E Pack B Pack B D Table A Then use Pack B to attach Left Side Rail(D) and Right Side Rail(E) to Front Leg Frame(B) and Hind Leg Frame(C). At this stage, only LOOSELY FASTEN the Screws.
Step 7 Place the Barstool on a Level Surface to see if it wobbles. If it wobbles, lift the Stool to some 30cm to 50cm height from the ground. Keep your feet and toes well away from the drop zone. Drop the chair freely and vertically with the four legs, hitting the ground, at the same time. This Drop Test will help to ensure that all the Bolts, Screws and gaps all reach full alignment status. Test again for evenness on a Level Surface. If no wobbles are found, proceed to tighten all the Bolts and Screws.
Page 9 OF 9