Caution: You must read this before you proceed.
Part NO.
Before Beginning Assembly: Pack A for assembling the Seat Frame(B) to the hind legs of Chair Back(A) Bolt(M6x80mm)+ Washer +Spring Washer Pack B for assembling the Seat Frame(B) to the Front Leg Left(C) & Front Leg Right(D) Bolt(M6x50mm)+ Washer +Spring Washer Pack C for assembling the Seat Frame (B) to the horizontal panel of Chair Back (A) at the central point Bolt(M6x45mm)+ Washer +Spring Washer+ Allen Key Pack D for assembling the Left Side Rails(E) &Right Side Rails(F) to the Left Front Leg (C)&
Chair Back (A) Chair Seat (B) Left Leg (C) Left side Rail (E) Front Rail (F) Right side Rail (F) FRONT FACING Right Leg (D) This Bar Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Bar Chair parts, the above picture is to help you put the various Table parts into perspective. Please read through the instructions herebelow to familiarise yourself with the parts and steps before assembly. Step 1 A. Chair Back B.
Step 2 Align the mounting positions of the Chair Back(A) and Chair Seat Frame(B). Use your left hand to push the seat frame floorwards, depicted by Arrow 1, this action helps to ensure the Chair Seat(B) is pressed towards to the Chair Back(A) with no gap between them.
Step 4 D C A B Place the chair onto the side of a table as seen in picture. Whith your assistant help to hold the front leg frame insert to the Chair Seat (B) Step 5 Step 5.1 F Step 5.2 F E E Pushing outwards A A A B B 5.1 Place Right Side Rail (F) Into the housing of the Hind Leg of the chair Back (A) and Right Leg (D). You may need to apply a little pressure to the front leg frame - pushing outwards, so as to enable the Side Rail (F) to be slotted into position. 5.
Step 6 D C 6 5 2 7 B Attach the Left Front Leg (C) And Right Front Leg (D) to the Chair Seat (B) Using Pack B. At this stage, only LOOSELY FASTEN the Bolts. Step 7 F 8 4 E D E C B Then use Pack D & Pack E to attach Side Rail (E) and Side Rail (F) to the Chair Back (A) and Left Leg (C) and Right Leg (D).
Place the chair on a Level Surface to check if it wobbles. If it is wobbles, lift the chair some 30cm to 50cm high from the ground, keep your feet and toes well away from the drop zone, and drop the chair freely and vertically with the four legs, hitting the ground at the same time. This Drop Test will help to ensure that all the bolts and gaps to all reach full alignment. test again for evenness on a Level Surface. If no wobbles are found, proceed to tighten all the Bolts.
Page 9 OF 9