Installation & Assembly

Assembly Instruction
1. Identify all parts packed in carton against the part list. Remove all protective material
carefully and avoid cutting the surface of the furniture while removing the wrapped
material.
2. Place the base on a non-abrasive, flat surface. Remove the bolts and nuts from the glass
springs at the open end of the rocker mechanism (See diagram).
3. Note the arrow labels on the rocker mechanism and on the chair support bar. Place the
bar on top of the glass spring and make sure the arrows are pointed at same direction in
front of the chair.
4. Align the holes on the support bar , the holes on the glass springs and the plate keeper.
Glide the bolts through the holes. Place the plate keeper beneath the glass springs and
glide the bolts through the holes on the plate. Fasten the four parts together with flat
washers and nuts. (See diagram).
5. Tighten all the bolts and nuts including the ones at the front part on the rocker
mechanism. Test the swivel rocker gently. If the rocker does not rock properly, double
check the assembly procedure, especially step 3.
Parts
Description
Quantity
Parts
Description
Quantity
Chair Bucket
（A）
1
Bolt(C)
8
Base(B)
1
Flat Washer(E)
8
Plate Keeper
(D)
6
Nut(F)
8
Warning: Do not force components and over tighten the nuts during assembly.