Assembly Instructions

Carefully unpack all lamp parts from the carton.
1.Take the lamp carefully out of the Carton, and place it on a flat surface.
2. Be sure the power to the installation point is power off.
3.Fasten the Cross bar to the outlet box. Locate the Nipple and the Washer, then thread them into the center of the Cross Bar.
4.Secure the Nipple onto the Canopy.
5.Connect the Chain and the Loop with the Quick Link.
6.Pass supply wire through the Loop and Quick Link, then wind onto the Chain and thread from the center of the Cross Bar.
7.The power supply wire consists of three wires, one smooth, one ribbed and one gold ground wire.
8.Connect the wires as shown : A.Connect the House Gound Wire to the Fixture Ground Wire.
B.Connect the House White or Ribbed Wire to the Fixture Supply Wire (White or Ribbed Side).
C.Connect the House Black/Red Wire to the Fixtrue Supply Wire (Black or Smooth Side).
D.Wrap each connected wire with Wire Connector and carefully stuff all of the connected wires into the Outlet Box.
9.Install correct Bulb referring to fixture markings and/or labels for maximum wattage. (Not included)
ASSEMBLY INSTRUCTIONS