Installation & Assembly

Circular strap

Mounting

screws

Wire

connencors

1ea Φ102*1.5tmm 4ea 8/32T*1-1/4"L 3ea Orange

Hex nut Deco nut

Finials

2ea Φ9*3.5tmm 2ea Φ12*10hmm 2ea Φ36*55hmm

Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)

Comments

IXTURE

SSEMBLY

NSTRUCTIONS

For Customer Service, contact the place of purchase to arrange for replacement parts.

NOTE: I

NSTALL THE GLASS ASSEMBLY

AFTER THE FIXTURE IS HUNG.

1. Attach the Finials (I) to each end of the bath bar

(J) by twisting in a clockwise direction.

2. Place the Glass Shade (F)over the Socket (G).

3. Holding the Glass Shade (F), place the Socket

Washer(I)over the Threaded Socket(G).

4. Secure Glass Shade (F) and Socket Washer (I)

by threading the Socket Ring (H) onto the Threaded

Socket (G) until tight.

5. Install the light bulb in accordance with the

fixture's specifications.

(DO NOT EXCEED MAXIMUM WATTAGE RATING!)

Fig 1

Read and review installation instruction sheet

before assembling the fixture.

PARTS & ASSEMBLY SHEET

This fixture assembled PO:__________ Date: ________

Notice:

Please review the parts listing and check for all parts before assembling the fixture. If any

parts are missing or damaged, please note onthis sheet and contact the place of purchase to

arrange for replacement parts.

PARTS LIST

Company Name:_______________________Co. Account #:_____________

to be filled out by retailer

PAGE 1
PARTS & ASSEMBLY SHEET This fixture assembled PO:__________ Date: ________ Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note onthis sheet and contact the place of purchase to arrange for replacement parts. PARTS LIST Company Name:_______________________Co. Account #:_____________ to be filled out by retailer Circular strap Mounting screws Wire connencors 1ea 4ea 3ea Orange Φ102*1.
PAGE 2
INSTALLATION INSTRUCTIONS Fixture Name: For Wall Mount Light Fixture WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. HANGING THE FIXTURE (Fig.1) 1. Carefully remove the new fixture from the carton and the yellow bag that holes all your parts. Check that all parts are included as shown in the illustration and parts list. 2. Shut off power at the circuit breaker and remove the old fixture from wall, including the old mounting strap. 3.