Installation & Assembly

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
MOUNTING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old
fixture and all hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the parts
on a clear area. Take care not to lose any small parts
necessary for installation.
3. Attach the mounting screw part way into the side hole of
the crook cross bar, then lock it securely with hex nut until
becoming.
4. Attach the cross bar to the Junction Box with the two Box
screws as shown. The side of the cross bar marked "GND"
must face out. The junction box is not included.
5. While holding the lamp body(C) towards the ceiling,
connect the electrical wires as Shown in Fig.2, making
sure that all wire nuts are secured. You may have to wrap
the connections with electrical tape. If your outlet has a
ground wire (green or bare copper), connect the fixture
ground wire to it. Otherwise connect fixture’s ground wire
directly to the Mounting strap with the green screw
provided. After wires are connected, tuck them carefully
inside the Junction Box.
6. Put lamp body(C) onto the junction box, aligning screws on
crook cross bar with mounting holes in lamp body and lock
it securely with the ball nut (A). Attach the socket sleeve(B)
insert to the lamp holder.
7. Install the light bulbs in accordance with the fixture’s
specifications. NOTE: DO NOT EXCEED THE
SPECIFIED WATTAGE.
Your installation is now complete. Return power to the
junction box and test the fixture.
Fig.1
Fig.2
MIN 90℃ SUPPLY CONDUCTORS
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE
(Not included)
ASSEMBLING & INSTALLATION INSTRUCTIONS PRODUCT
For Ceiling Mount Light Fixture