Assembly Instructions ASSEMBLY RATING Tools Required For Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in Allen Wrench = nn 1) assembling a specific product (with 1 being (denuded) easy and 5 being difficult). For some products, two persons are recommended. . .
ASSEMBLY & CARE ADVICE FOR YOUR FURNITURE TO LAST,CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY. PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE. BASIC ASSEMBLY TECHNIQUES y When lock or spring washer is used in Position each part correctly and insert Use cardboard or carpet area when an assembly, please make sure the screws or bolts into their respective assembling furniture to prevent lock or spring washer is placed holes by hand tighten or using the scratches .
Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed.
Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed. Hardware List #A x docs Dowel M10 x 40mm #C x PCs Bolt 1/4" x #E x PCs Flat Washer #G x apes Wood Button @14.5 #l x PCs CSK M3.
#A x PCs Note: Left and right is determined by facing the front of the headboard in its upright position. 1. Insert a dowel (#A) into the top hole on each end of the headboard Insert the other end of the dowels (#A) into the per-drilled holes along the top of the right/left headboard legs #2 Make sure to insert the sides of the headboard (#1) into the designated slots along the legs #B x PCs #C x PCs #D x PCs #E x PCs #G x PCs 1.
#A x PCs Note: Left and right is determined #5 #4 the top hole on each end 2. Insert the other end of the dowels (#4) into the per-drilled holes along the top of the right/left foot board legs by facing the front of the foot board in its upright position. 1. Insert a dowel (#A) into of the foot board Make sure to insert the sides of the foot board (#4) into the designated slots along the legs #B x PCs #C x PCs #D x PCs #E x PCs #G x PCs 1.
#l x PCs #J x PCs 2. Align the brackets (#1) to each rail end and draughtboard board. Insert 4 screws (#1) into each bracket and secure using a Phillips screwdriver. 1. Hook the ends of the side rails (#7) into the slots along the headboard/footboard legs. 2. Insert a screw (#H) into each 6-2 end of the slats Secure using a Phillips screwdriver. 1.