Installation Instructions

PREPARATION
- Shut o the power at the circuit breaker and remove existing xture, including the mounting hardware.
- Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
CONNECTING THE WIRES (FIG. 2)
1. Remove the mounting screws (C1) from the xture, remove P1 wire connectors (D1).
2. Connect the driver input wires to supply wires as shown in Fig. 2. Make sure that all P3 wire connectors (A1) are secured.
3. If your outlet box has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground
wire directly to the mounting plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
*Requires driver to be recessed within the junction box.
MOUNTING THE FIXTURE (FIG. 1)
4. Secure the mounting plate to the junction box using the junction box screws (B1).
The side of the mounting plate marked “GND” must face out.
5. Connect the driver output wire to the xture wires,
secure with p1 wire connectors (D1).
6. Place the xture back plate over the mounting plate and
secure with the mounting screws (C1).
7. Thread the glass onto the lamp holder on the xture until tight.
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2
Fig. 1
Output Wire
P1 Wire
Connector
P3 Wire Connector
Fixture
Back Plate
Input Wire
Supply Wire
Junction Box
Ground Wire
Driver
Mounting
Plate
Junction
Box Screw
Mounting
Screw
D1 A1
B1
C1
INSTALLATION INSTRUCTION
2