Installation Instructions

INSTALLATION INSTRUCTIONS
Fig.1
Fig. 2
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or
Bare
Copper
(Ground
)
FOR YOUR SAFETY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON
IS SHUT OFF; EITHER THE FUSE IS REMOVED OR THE CIRCUIT BREAKER IS SHUT OFF. GENERAL
You don’t need special tools to install this fixture. Be sure to follow the steps in the order given. Under no
circumstances should a fixture be hung on house electrical wires, nor should a swag type fixture be installed on a
ceiling which contains a radiant type heating system. Read instructions carefully. If you are unclear as to how to
proceed, consult a qualified electrician.
NOTE: Proper wiring is essential for the safe operation of this fixture.
HANGING THE FIXTURE (Fig. 1)
1. Shut off the power at the circuit breaker and remove
the old fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts necessary for installation.
CONNECTINE THE WIRES (Fig.2)
3. While supporting the fixture, connect the electrical
wires as shown in figure 2. If your post has a ground
wire (green or bare copper), connect the fixture ground
wire to it. If not, consult your electrician for proper
grounding. After the wires are connected, tuck them
carefully inside the post (A).
4. Place the fixture onto pole, and secure with the 3
mounting screws (B)
COMPLETING THE INSTALLATION (Fig. 1)
5. Take off the roof (E) from the cage (D) by loosening two
screws (C), install the bulb (E12 Candelabra base, not
included.) in accordance with the fixture’s specification.
Attach the roof (E) back to the cage (D) by two screws
(C).
DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
Your installation is now complete. Return power to
the junction box and test the fixture