Caution : You must read this before you proceed Table Picture Label Picture Description QTY A Table Top 1 B Table Leg with preattached Levellers 4 C Round Support 1 Page 1 OF 7
Label Picture Description QTY ① Bolt(M8*35mm) 9 ② Washer(8mm) 13 ③ Spring Washer(8mm) 13 ④ Nut(8mm) 9 ⑤ Hex Bolt(M8*45mm) 5 ⑥ Spanner 1 ⑦ Screwdriver 1 ⑧ Rubber Cap 9 Before Beginning Assembly: Page 2 OF 7
Overview Table Top(A) Table Leg(B) Round Support(c) FRONT FACING This Table has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1 Unpack and place all parts on a clean, soft surface. Step 2 Lay the Table Top(A), facedown, onto a flat, soft, clean surface and lock the mounting positions with bolts(①) by using Screwdriver(⑥). DO NOT OVERTIGHTEN.
Step 3 Attach the table leg with pre-attached Levellers(B) to the table top(A) using washers(②),spring washers(③),and nuts(④) with spanner(⑦). DO NOT OVERTIGHTEN. Step 4 Repeat step 3, attaching the remaining 3 legs to the Table top(A). At this stage, only loosely tighten the Bolts.
Step 5 Loosely attach the round support (C) to Table Leg with pre-attached Levellers(B) with washers(②),spring washers(③) and hex nuts(⑤),using the spanner(⑦). Tighten all these Nuts and Washers in a sequential manner. DO NOT OVERTIGHTEN. Step 6 Adjust height Adjust low for balance Stand the table right side up. Now, fully and securely, tighten all nuts, at all joints. Add Rubber Caps(⑧) on all bolt ends to protect skin or clothing from getting snagged.
Page 7 OF 7
