Installation & Assembly

2-Bolt
฀1/4"*1-1/4"L
Read all instructions before starting assembly.
Step #1 Checked all the components listed in "packaged"
are included. Prepare a flat and protected work surface,
being careful not to scratch the finish.
Step #2 Position the Easel Assembly (B) with back post
pulled out to a desired angle and make sure it is steady and
not wobbling.
Step #3 Position Canvas Holder's notch (C) to the bottom
up second hole of the Ease Assembly (B) front post and
attach to the Pressure Bar (D) by using Bolts (A) and
securely tightened.
Step #4 Push the Peg (E) through the hole of Canvas
Holder and connect to the corresponding hole of the
Easel Assembly (B) front post and the Pressure Bar (D) .