User's Manual

Subject: PRODUCT ENGINEERING
SPECIFICATION
Part No.: 9Z.P5E**.***; Rev.: 0
Doc. No.:
201-C001
Project Code:
9Z.P5E81.001
Page 29 of 33
Model Name:
U10B
Release Notice
Coating heap(堆疊) ≤0.1mm²
Appearance of
laser etching
legend
”e” & “i” width tolerance is ±0.05mm
Folding mark of
MEM tail
No function issue, mark can’t be through MEM tail width and broken surface can’t be
acceptable.
The amount of “LINE” type folding mark is not more than two and the gap between them
is larger than 10mm.
The amount of “SPOT” type folding mark is not more than four.
Arch for RUB
Mylar
Folding edge of metal plate: Arched height of RUB Mylar must be lower than folding
edge of metal plate with normal function.
No folding edge of metal plate: Arched height of RUB Mylar must be lower than 1/2
height between Keycap and metal plate(Z height).
Scratch for RUB
Mylar
Scratch with raw material: ≤0.2mm²
Sensed scratch without raw material: Width ≤0.1mm, Length ≤3mm
Senseless scratch: Width ≤0.2mm, Length ≤10mm
Folding mark of
RUB Mylar or
PET
Folding mark direction by X-direction: It is acceptable to be less than 3 marks for whole
keyboard but can’t be found on adjacent locations and the distance must be larger than
100mm between 2 marks; The following picture is NG sample.
Folding mark direction by Y-direction: Length <5mm, less than 3 marks for whole
keyboard.
Appearance of
AL Foil
1. Break can’t be acceptable.
2. Folding mark length <1/3 long length of Foil and not more than 3 marks within each
50mm.
3. Senseless scratch and finger marks can be acceptable.
Paint appearance
of metal plate
edge
Paint loss area ≤0.2mm²
Specification of
Keycap color
comparison
△
E <1.0,
△
L, a, b <0.4
Form No.: A-01-001-09(111107) 保存期限:最新狀態 保存單位:eGRNSystem
過期處置:背面紙