User Manual

Table Of Contents

Wireless Optical Mouse for Laptops

Quick Setup Guide

1. Left Mouse Button

2. Right Mouse Button

3. Scroll Wheel

4. Battery Cover

5. Smart Receiver Storage Compartment

6. Battery Cover Release Button

7. Wireless Receiver Eject Button

8. Mouse CONNECT Button

9. Wireless Receiver CONNECT Button

System requirements

 IBM® compatible system or Macintosh®

 Windows 98, 2000, Me, XP or Mac OS 10.0 or later

 An available USB Port

Installation instruction

Battery installation

1. Press the 「Battery Cover Release Button」to remove the battery cover.

2. Install two AAA alkaline batteries in the mouse.

3. Slide and lock battery cover back in place.

Operating Instructions

1. Plug the wireless receiver into the USB port of your system (Your system will automatically

detect for new hardware).

2. To activate the mouse, please press and release the CONNECT button located on the

bottom of the mouse.

3. Press and release the CONNECT button on the wireless receiver. (Please make sure to

perform step 2 & 3 within 10 seconds of each other.) Repeat Step 2 & 3 if the mouse is not

activated.

4. Smart Receiver Storage & Manual Power Down

 This Wireless Optical Mouse for Laptops automatically powers OFF when the wireless

receiver is stored in the Smart Receiver Storage Compartment. This feature will extend

the life of the battery and eliminate the chance of leaving the wireless receiver behind.

The mouse will automatically power ON when the wireless receiver is released from the

Smart Receiver Storage Compartment.

PAGE 1
Wireless Optical Mouse for Laptops Quick Setup Guide 1. Left Mouse Button 2. Right Mouse Button 3. Scroll Wheel 4. Battery Cover 5. Smart Receiver Storage Compartment 6. Battery Cover Release Button 7. Wireless Receiver Eject Button 8. Mouse CONNECT Button 9. Wireless Receiver CONNECT Button System requirements IBM® compatible system or Macintosh® Windows 98, 2000, Me, XP or Mac OS 10.0 or later An available USB Port Installation instruction Battery installation 1.
PAGE 2
You can manually power the mouse OFF by pressing the Left and Right Mouse Buttons and Scroll Wheel Button simultaneously. Press any mouse button to turn the power ON. In order to further extend the battery life of your Wireless Optical Mouse for Laptops, the mouse will automatically goes into sleep mode after 5 minutes if no activity or movement is detected. To resume normal operation, either move the mouse or press any of the mouse buttons. 5.
PAGE 3
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.