User guide

III. Using the telephone LJ-100

To select one ringer melody:

♦ press the SET/HOLD button. The display

will show - 0 1 2 3 4 5 6 7 -.

♦ Press the 7 button. The display will show

an actual setting rING 09. The ringer

melody will be played.

♦ Press the UP/+ or DOWN/- button to

select the right signal (melody).

♦ Press the SET/HOLD button to confirm

the setting. The display will show the

symbol - 0 1 2 3 4 5 6 7 – again.

♦ Press the DEL/TIME button. The

telephone will return to the standby mode.

If the DEL/TIME button is not pressed, the

telephone will return to standby mode after

several seconds. The setting will be stored.

Note!

The melody ringers are available only, when the batteries are

placed in the battery compartment. If there are no batteries,

only the normal ringer will sound.

# 2-way speaker function

The 2-way speakerphone function allows a number to be dialed, or a call to be

made, without the handset needing to be lifted. The party on the other end of

the line will automatically be able to hear and to be heard through the speaker

located in the base unit of the telephone. When using this function, the user

needs to speak within a reasonable distance of the telephone microphone in

order that the microphone may pick-up voice sound. This function may also be

used to make a conference call between several parties in the same office.

Using the SP-PHONE button, the 2-way speakerphone function can be

switched on/off.

After pressing the SP-PHONE button, the

display will show the timer.

In addition, the VOLUME HI/LOW rotary

switch can be used to adjust the volume of the

loudspeaker.

SET/HOLD

UP/+ DOWN/-

BC DEF

GHI JKL MNO

PQRS TUV WXYZ

OPER

DEL/TIME

SP-PHONE

VOLUME