User guide

20
III. Using the telephone LJ-102
♦ Press the UP/x or DOWN/÷
÷÷
÷ button. The
display will show 00-- 00. The first two
zeroes will be flashing.
♦ Press the UP/x or DOWN/÷
÷÷
÷ button to set
the right hour.
♦ Press the SET/CE button. The digits
indicating the minutes will begin to flash.
♦ Press the UP/x or DOWN/÷
÷÷
÷ button to set
the right minutes.
♦ Press the SET/CE button to confirm the
setting. The display will show the time
set SEt 6 AL2. Repeat the
above steps to set the second alarm.
After confirmation of the second alarm,
the display will show the time set
♦ SEt 6 AL3. Now the third alarm can
be set. If you do not want to set a further
alarm, press the DEL/+ button. The
telephone will return to the standby
mode.
The alarm signal will be played every day. The alarm can be switched off by
pressing the DEL/+ button (or any other).
Note!
The alarm function is available, only when the batteries are located in the battery
compartment or the power supply is connected to the base unit.
# „No disturb” function.
Your telephone allows the ringer to be switched off.
The telephone will not then ring, with the exception of the VIP numbers
(see chapter :„VIP function” ).
To switch the ringer off:
♦ press and hold the VIP button until the
display shows 00-- 00. The two first
zeroes will flash.
♦ Press the UP/x or DOWN/÷
÷÷
÷ button to set
the right hour.
DEL / +
SET / CE
UP / x DOWN /
VIP
UP / x DOWN /