User guide

IV. Clip (Caller ID)- Calling line identification presentation LJ-102

In standby mode, the display shows all the clip numbers, for example,

34.

The number is identified and stored in the following form:

for example- 0 42 1234567,

The identified number consists of:

0- prefix,

42- local area code,

1234567- number of subscriber.

Note!

If the clip memory is full, storing a new number automatically clears the first stored number.

# How to review Clip numbers

If new numbers are stored, the display shows the NEW symbol. The number

is displayed until the UP/x or DOWN/÷

÷÷

÷ button is pressed or the handset

lifted.

To review new numbers:

! press the UP/x button, the display shows the number stored in the

lower memory location, the counter shows the number of the

memory location,

! press the DOWN/÷

÷÷

÷ button to display the number stored in the higher

memory location.

! use the UP/x and DOWN/÷

÷÷

÷ buttons to review all new numbers.

After displaying new numbers, the NEW symbol disappears from the display.

New numbers change their status to old numbers.

Note!

If there are no numbers in the memory, after pressing one of the buttons, the display will be

blank.

Note!

If the clip memory is full, storing a new number automatically clears the first stored number.

To review the old numbers:

! press the UP/x or DOWN/÷

÷÷

÷ button, the display will show the last

number displayed.

! After next pressing the UP/x button, the display will show the

numbers stored in the lower memory location.

! After next pressing the DOWN/÷

÷÷

÷ button, the display will show the

numbers stored in the higher memory location.