User guide

27
IV. Clip (Caller ID)- Calling line identification presentation LJ-102
♦ Press the UP/x button twice. The display
will show SEt 3 PCOdE.
♦ Press the SET/CE button. The display
will show a flashing dash.
♦ Press the UP/x or DOWN/÷
÷÷
÷ button to
enter the right prefix.
♦ Press the SET/CE button to confirm the
setting. The display will show SET 4
LCd.
♦ Press the DEL/+ button. The telephone
will return to the standby mode.
Note!
To remove the prefix, enter a dash instead of a digit.
# How to enter the local area code
At present, a local area code does not need to be entered to make local
calls. This function can only be used to specify local numbers. Entering a
local area code in the memory removes it from all numbers, which belong to
the same area.
To enter the local area code:
♦ press the SET/CE button. The display
will show SEt 1 dAtE.
♦ Press the UP/x button. The display will
show SEt 2 COdE.
♦ Press the SET/CE button again. The
display will show 0 - - - - . The digit 0
will flash.
Note!
The digit 0 indicates a prefix. If you want to change a prefix, use the UP/x or
DOWN/÷
÷÷
÷button.
♦ Press the SET/CE button. The first dash
will start to flash.
♦ Press the UP/x or DOWN/÷
÷÷
÷ button to
enter the first digit of the local area
code.
♦ Press the SET/CE button. The second
dash will start to flash.
UP / x
SET / CE
UP / x DOWN /
DEL / +
SET / CE
UP / x
SET / CE
SET / CE
UP / x DOWN /