User manual

17
Manual del Usuario / action 500 series / User’s Manual
1 2
live off
0.0m
O
+ 2 dB
1
C
2
live off
0.0m
O
INPUT
CLIP
1
L
2
live off
0.0m
O
LIMIT
MAIN MENU
BACK
PRESET: Live
HPF: Off
1 2
live off
0.0m
O
0 dB
live preset
MAIN MENU
BACK
PRESET: Live
HPF: Off
MAIN MENU
BACK
HPF: Off
PRESET: Live >
MAIN MENU
BACK
HPF: Off
PRESET: <dance>
MAIN MENU
BACK
HPF: Off
PRESET:<monitor>
Differences between Presets
DISPLAY (except ACTION-S18A, ACTION-S118A & ACTION-S218A)
1 2
live off
0.0m
O
0 dB
ADJUSTING THE LEVELS:
By default the state of the screen is the
following:
Once the input source (s) have been
connected to the amplifier´s cabinet, the user has
to adjust the levels.
For the two input channels (1 and 2), two
independent gain controls are available. Be
careful when setting the input volume and do not
exceed the maximum level shown on the meters:
(input clip shown on channel one)
peak
meters
RMS
meter
Exceeding the limits
may cause
speaker failure!!
Exceeding the limits
may cause
speaker failure!!
After having set the input volume values
under the maximum level, user has to adjust
ouput volume with the master control. The level
is shown in the right meter of the screen. As with
the inputs be careful not exceeding the limit:
(LIMIT shown)
After these two volume adjustments the
screen will show something like this (when
having the input sources ON):
It is highly recommendable
working with output volume
below 0dB. If maximum level
is required user should
increase the output level
(higher than 0dB)
MAIN MENU:
As stated previously by pushing the encoder
the user can access to the following options in
the MENU:
Note: to enter and select and option always push the encoder. For going back in the menu, the user
has to select Back on the screen and press the encoder or just pushing the encoder.
After 30 seconds without using the unit it will go back to the main screen automatically.
PRESETS:
Three factory settings (live, dance, monitor)
depending on the type of music/use that has
been configured inside the unit:
With the encoder go to Preset Sub-menu and
press the knob to access to the different options:
Notes:
The only models in this series that do not
have a display are: ACTION-S118A and ACTION-
S218A.
In the model ACTION-M512A the preset
activated by default is "Monitor" while in the
other models it is "Live". While your preset is
"Monitor" the display will turn off completely
during use.
If in the "LOGO" menu we have chosen the
"Limit" option, the anagram will flash when the
limiter is activated. If we have chosen "On" it will
remain lit, while if the option chosen is "Off" it
will remain off.
10k5k2k1k500200100502020 20k
dBSPL
10k5k2k1k500200100502020 20k
dBSPL
10k5k2k1k500200100502020 20k
dBSPL
Live
Dance
Monitor