User manual

20
Manual del Usuario / action 500 series / User’s Manual
1 2
loud Top
0.0m
O
0 dB
INPUT
CLIP
C
DISPLAY (only ACTION-S18A)
ADJUSTING THE LEVELS
By default the state of the screen is the
following:
Once the input source has been connected to
the amplifier´s cabinet, the user has to check the
gain structure of the system.
Adjust level output from your processor
and/or mixing console in order to prevent INPUT
CLIP (left signal meter):
peak
meters
RMS
meter
Exceeding the limits
may cause damage
in the system
Exceeding the limits
may cause damage
in the system
PRESETS:
Two factory settings (loud and deep)
depending on the type of music/use has been
configured by default:
With the encoder go to Preset Sub-menu
and press the knob to access the different
options:
By scrolling down the encoder more options
appear:
1 2
loud Top
0.0m
O
0 dB
1 2
loud Top
0.0m
O
0 dB
LIMIT
L
1 2
loud Top
0.0m
O
0 dB
MAIN MENU
BACK
PRESET: loud
LPF: Top
MAIN MENU
BACK
OPTIONS: off
Delay: 0.0m
1 2
loud Top
0.0m
O
0 dB
loud preset
MAIN MENU
MAIN MENU
MAIN MENU
BACK
BACK
BACK
PRESET: loud
LPF: Top
LPF: Top
LPF: Top
PRESET: loud >
PRESET: <deep
MAIN MENU
MAIN MENU
MAIN MENU
BACK
BACK
BACK
PRESET: loud
PRESET: loud
PRESET: loud
LPF (Low Pass Filter):
There are 3 different options:
LPF: Top>
LPF:<63Hz>
LPF:<100Hz
Combination with
ACTION-508A, ACTION-M512A,
ACTION-512A, ACTION-515A
and ACTION-525A
10k5k2k1k500200100502020 20k
dBSPL
10k5k2k1k500200100502020 20k
dBSPL
After having set the input volume values
under the maximum level, user has to adjust
ouput volume with the master control. The level
is shown in the right meter of the screen. As with
the inputs be careful not exceeding the limit:
(LIMIT shown)
After these two volume adjustments the
screen will show something like this (when
having the input sources ON):
MAIN MENU:
As stated previously by pushing the encoder
the user can access to the following options in
the MENU:
Note: to enter and select and option always push the encoder. For going back in the menu, the user
has to select Back on the screen and press the encoder or just pushing the encoder.
After 30 seconds without using the unit it will go back to the main screen automatically.