Installation manual

© Hills Industries 2009 Page 25
Feature 8 Phone Number Three (3)
Segments 1-20
14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14
The third telephone number is programmed in Feature 8.
’15’ = pulse dialling - in the segment where pulse dialling should begin
’14’ indicates the end of the phone number. Fill all empty segments after end of dialling with ‘14’
’13’ = four second delay - in the segment where a delay is required
’12’ = a ‘#’ - in the segment as required
‘11’ = for a ‘’ - in the segment as required
Feature 9 Event Report Summary
Feature 9 is a summary of event reporting codes found in the area and system features. Area report events are enabled in
area options, but will also need to be enabled in this feature. This approach is used to simplify event selection
programming.
Segment 1
(1)
Alarms
(2)
Alarm Restores
3
Opening / Closing (alarm system disarmed = open, alarm system armed = close)
(4)
Bypass and Bypass Restore
5
Zone Trouble and Restore
(6)
Power Trouble (AC Failure or Low Battery) and Restore
7
Tampers and Restore (Zone, Box, Code Pad and also for Zone Activity Monitor)
(8)
Test Reports
Segment 2
(1)
System Trouble (siren / phone / expander / short circuit) and Restore
(2)
Failure to Communicate
(3)
Sensor Lost / Sensor Low Battery
4
Program, Download, & Full Log (Full Log must also be enabled in system options)
(5)
Cancel Code (Cancel reporting must also be enabled in area options)
6
Recent Closing / Exit Error
7
Reserved
8
Reserved
Feature 10 Dial Attempts and Dialing Options
Segments 1-2 6 0
Feature 10, Segment 1 is used to enter the number of dial attempts (1 to 15 attempts) the communicator will make to phone
#1 before ending the notification process. Factory default is ‘6’ and the communicator will make 6 attempts to the first
number.
Feature 10, Segment 2 configures additional functionality. Factory default is “0” – no function.
A value of “1” enables Dual Reports – sends reports to both phone number 1 & 2.
A value of “4” enables extended phone number and joins Feature 4 & 7 together for a 40 digit phone number.
Feature 11 Phone Line Cut Delay
Segment 1 0
Feature 11 contains the number of second increments in the telephone line monitor delay before phone line fault is
activated. The telephone line monitor delay can be programmed in 1 second increments from 1 to 255 seconds.
Note: The Hills Reliance 128 and 12 internal phone line monitoring circuit requires approximately 5 seconds to discharge
before it senses a missing phone line, you must add this time to the value in this feature when testing this option. A value of
“0” = disabled.